IPv4 subnetting
- Hosts per subnet
- 2(32 − prefix) − 2 (/31: 2, /32: 1)
- Block size
- 256 − (mask octet)
- Network address
- IP AND mask
- Broadcast address
- IP OR (NOT mask): all host bits set to 1
- Subnets from n borrowed bits
- 2n
Formula sheets, the key method steps for every topic and 6 practice problems, with full solutions at the back.
A subnet uses the mask 255.255.254.0. How many usable host addresses H does it have?
A host has the address 10.20.209.70/29. What is the last number (fourth octet) x of its subnet's broadcast address?
Why does a switch sometimes send a frame out of all ports except the one it came in on?
With sliding-window protocols, how does Go-Back-N differ from Selective Repeat after one frame is lost?
Set the bits so they store −71 in 8-bit two's complement. Read as an unsigned number, what is the pattern's value U?
Set the bits to the 8-bit result of 1100 0010 >> 1. What is the result's value R in decimal?
Answer: H = 510
IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).
Answer: x = 71
IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).
Answer: B · The destination MAC address is not yet in its address table
For an unknown unicast address the switch floods the frame. When the destination replies, the switch learns its port from the source MAC.
Answer: A · Go-Back-N resends the lost frame and all later ones; Selective Repeat only the lost one
A Go-Back-N receiver discards out-of-order frames, so the sender must repeat everything after the loss. Selective Repeat buffers them and asks only for the missing one.
Answer: U = 185
Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.
Answer: R = 97
Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.
Shifting right by 1 moves every bit 1 places to the right; bits that fall off the right end are lost and zeros come in on the left.
ExamProblems · examproblems.com/courses/computer-networks