IPv4 subnetting
- Hosts per subnet
- 2(32 − prefix) − 2 (/31: 2, /32: 1)
- Block size
- 256 − (mask octet)
- Network address
- IP AND mask
- Broadcast address
- IP OR (NOT mask): all host bits set to 1
- Subnets from n borrowed bits
- 2n
Formula sheets, the key method steps for every topic and 6 practice problems, with full solutions at the back.
The network 10.234.244.0/22 is divided into equal subnets with prefix /25. How many subnets N are there?
A host has the address 10.20.55.245/28. What is the last number (fourth octet) x of its subnet's broadcast address?
What does an MX record in DNS specify?
Hosts in VLAN 10 and VLAN 20 on the same switch cannot communicate. What is needed?
Set the bits so they store −101 in 8-bit two's complement. Read as an unsigned number, what is the pattern's value U?
Set the bits to the 8-bit result of 0010 1000 OR 1010 0101. What is the result's value R in decimal?
Answer: N = 8
IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).
Each /25 subnet has 27 − 2 = 126 usable hosts.
Answer: x = 255
IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).
Answer: D · The mail servers that accept email for a domain
MX (mail exchange) records list mail servers with priorities, so sending servers know where to deliver mail for that domain.
Answer: B · A router or layer 3 switch to route between the VLANs
VLANs are isolated at layer 2, so traffic between them must be routed, for example by a router on a trunk ("router on a stick") or a layer 3 switch.
Answer: U = 155
Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.
Answer: R = 173
Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.
OR gives 1 where at least one bit is 1.
ExamProblems · examproblems.com/courses/computer-networks