IPv4 subnetting
- Hosts per subnet
- 2(32 − prefix) − 2 (/31: 2, /32: 1)
- Block size
- 256 − (mask octet)
- Network address
- IP AND mask
- Broadcast address
- IP OR (NOT mask): all host bits set to 1
- Subnets from n borrowed bits
- 2n
Formula sheets, the key method steps for every topic and 6 practice problems, with full solutions at the back.
A subnet uses the mask 255.255.240.0. How many usable host addresses H does it have?
The network 192.168.125.0/24 is split with VLSM for these LANs: A: 13 hosts, B: 22 hosts, C: 31 hosts, D: 42 hosts. Subnets are allocated from .0 upwards, the LAN with the most hosts first, each with the smallest subnet that fits. What is the fourth octet x of the network address of LAN C?
Why is UDP often preferred for live video calls?
Hosts in VLAN 10 and VLAN 20 on the same switch cannot communicate. What is needed?
Set the bits so they store −41 in 8-bit two's complement. Read as an unsigned number, what is the pattern's value U?
Set the bits to the 8-bit result of 1110 1001 OR 0100 0100. What is the result's value R in decimal?
Answer: H = 4094
IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).
Answer: x = 64
VLSM: each LAN gets the smallest subnet with 2ʰ − 2 ≥ its host count, i.e. prefix 32 − h. Allocating the largest subnets first keeps every block aligned on a multiple of its own size, so the network addresses follow by adding up the block sizes.
LAN C: 192.168.125.64/26.
Answer: B · Low delay matters more than retransmitting every lost packet
Retransmitting lost packets would add delay; real-time media tolerates some loss, so UDP-based protocols like RTP are used.
Answer: A · A router or layer 3 switch to route between the VLANs
VLANs are isolated at layer 2, so traffic between them must be routed, for example by a router on a trunk ("router on a stick") or a layer 3 switch.
Answer: U = 215
Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.
Answer: R = 237
Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.
OR gives 1 where at least one bit is 1.
ExamProblems · examproblems.com/courses/computer-networks