Computer Networks: cram pack

Formula sheets, the key method steps for every topic and 6 practice problems, with full solutions at the back.

New problemsBack to the course

In the print window, choose “Save as PDF” to keep a copy on your device.

1Formulas and methods

IPv4 subnetting

Hosts per subnet
2(32 − prefix) − 2 (/31: 2, /32: 1)
Block size
256 − (mask octet)
Network address
IP AND mask
Broadcast address
IP OR (NOT mask): all host bits set to 1
Subnets from n borrowed bits
2n

Number systems

Place values
binary 2k, octal 8k, hex 16k
To decimal
Σ dk·bk
From decimal
divide by the base, read the remainders bottom-up
Hex ↔ binary
one hex digit = 4 bits
Two’s complement
invert the bits and add 1

2Practice problems

1.IPv4 subnettingMedium
/24 → /2811111111111111111111111111110000network bitshost bits

The network 192.168.10.0/24 must be divided into at least 10 equal subnets. If you borrow as few bits as possible, how many usable hosts H does each subnet have?

192.168.10.0/2410 subnets
H =
2.IPv4 subnettingHard
last octet = 52012806413211608140201networkhost

A host has the address 10.20.109.52/28. What is the fourth octet x of the last usable host address in its subnet?

10.20.109.52/28
x =
3.Computer networksMedium

Why does a switch sometimes send a frame out of all ports except the one it came in on?

  1. AThe destination MAC address is not yet in its address table
  2. BThe frame has a wrong IP checksum and must be checked by every host
  3. CThe switch is acting as a router
  4. DThe frame is too large for one port
4.Computer networksHard

Hosts in VLAN 10 and VLAN 20 on the same switch cannot communicate. What is needed?

  1. AA router or layer 3 switch to route between the VLANs
  2. BA hub connected to both VLANs
  3. CA longer cable between the hosts
  4. DThe same MAC address on both hosts
5.Number systemsMedium
place values in two's complement1−12816413211618040201

The 8-bit pattern 1111 1000 stores a signed integer in two's complement. What is its value N in decimal?

1111 10008 bit
N =
6.Number systemsHard
click the bits to set them012806403201608040201

Set the bits to the 8-bit result of 1011 1110 OR 1001 0010. What is the result's value R in decimal?

1011 1110OR1001 0010
R =

3Solutions

1.IPv4 subnetting

Answer: H = 14

IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).

Bits to borrow

24 = 16 ≥ 10 → b = 4, /28

Hosts per subnet

24 − 2 = 14

Answer

H = 14
2.IPv4 subnetting

Answer: x = 62

IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).

Block size

24 = 16

Subnet of this host

network: ⌊52/16⌋·16 = 48
broadcast: 48 + 16 − 1 = 63
usable hosts: 49 … 62

Answer

x = 62
3.Computer networks

Answer: A · The destination MAC address is not yet in its address table

Why this is the answer

For an unknown unicast address the switch floods the frame. When the destination replies, the switch learns its port from the source MAC.

Answer

A · The destination MAC address is not yet in its address table
4.Computer networks

Answer: A · A router or layer 3 switch to route between the VLANs

Why this is the answer

VLANs are isolated at layer 2, so traffic between them must be routed, for example by a router on a trunk ("router on a stick") or a layer 3 switch.

Answer

A · A router or layer 3 switch to route between the VLANs
5.Number systems

Answer: N = −8

Positional number systems: each digit is worth its value times a power of the base. In binary the places are worth 1, 2, 4, 8, 16, …; in hexadecimal 1, 16, 256, …, with A–F standing for 10–15. In 8-bit two's complement the leftmost bit is worth −128 instead of +128, which is how negative numbers are stored.

Add the place values

The other bits keep their normal positive values.

−128 + 64 + 32 + 16 + 8 = −8

Answer

N = −8
6.Number systems

Answer: R = 190

Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.

Bit by bit

OR gives 1 where at least one bit is 1.

1011 1110
OR 1001 0010
= 1011 1110

Value of the result

1011 1110₂ = 190

Answer

R = 190

ExamProblems · examproblems.com/courses/computer-networks