IPv4 subnetting
- Hosts per subnet
- 2(32 − prefix) − 2 (/31: 2, /32: 1)
- Block size
- 256 − (mask octet)
- Network address
- IP AND mask
- Broadcast address
- IP OR (NOT mask): all host bits set to 1
- Subnets from n borrowed bits
- 2n
Formula sheets, the key method steps for every topic and 6 practice problems, with full solutions at the back.
The network 192.168.10.0/24 must be divided into at least 12 equal subnets. If you borrow as few bits as possible, how many usable hosts H does each subnet have?
A host has the address 10.20.232.178/29. What is the fourth octet x of its network address?
What is the main difference between the HTTP methods GET and POST?
Hosts in VLAN 10 and VLAN 20 on the same switch cannot communicate. What is needed?
Set the bits so they store −15 in 8-bit two's complement. Read as an unsigned number, what is the pattern's value U?
Set the bits to the 8-bit result of 0001 0110 >> 2. What is the result's value R in decimal?
Answer: H = 14
IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).
Answer: x = 176
IPv4 subnetting: an address has 32 bits. The prefix /p says how many leading bits identify the network; the remaining 32 − p bits number the hosts. A subnet has 2³²⁻ᵖ addresses, but the first (network address) and last (broadcast address) cannot be given to hosts, so 2³²⁻ᵖ − 2 hosts fit. Exceptions: a /31 (point-to-point link, RFC 3021) uses both of its 2 addresses for hosts, and a /32 is one single address (a single host or a loopback).
Answer: D · GET retrieves a resource, POST submits data in the request body
GET asks for a resource and should not change server state. POST sends data, such as a form, in the body for the server to process.
Answer: D · A router or layer 3 switch to route between the VLANs
VLANs are isolated at layer 2, so traffic between them must be routed, for example by a router on a trunk ("router on a stick") or a layer 3 switch.
Answer: U = 241
Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.
Answer: R = 5
Setting bits: each bit is worth a power of two (128, 64, …, 1). One hex digit is exactly four bits, and in 8-bit two's complement the leftmost bit is worth −128. Bitwise operations work on each bit position separately.
Shifting right by 2 moves every bit 2 places to the right; bits that fall off the right end are lost and zeros come in on the left.
ExamProblems · examproblems.com/courses/computer-networks