Number systems
- Place values
- binary 2k, octal 8k, hex 16k
- To decimal
- Σ dk·bk
- From decimal
- divide by the base, read the remainders bottom-up
- Hex ↔ binary
- one hex digit = 4 bits
- Two’s complement
- invert the bits and add 1
Formula sheets, the key method steps for every topic and 6 practice problems, with full solutions at the back.
The 8-bit pattern 1011 0111 stores a signed integer in two's complement. What is its value N in decimal?
What is the most negative integer N that can be stored in 20-bit two's complement?
Simplify F = AC + BC′ + A′B′C + ABC′ to its minimal sum-of-products form. How many literals L does the simplified expression contain?
A 4-bit shift register Q₃Q₂Q₁Q₀ holds 0110. At every clock edge the bits shift one place to the right (Q₃ → Q₂ → Q₁ → Q₀, Q₀ is lost) and the serial input enters Q₃. The serial input is 0, 1, 0, 1, 0 at the 5 edges. Give the final state Q = Q₃Q₂Q₁Q₀ as a decimal number.
A UART sends bytes at 38400 baud in the format 8N1: 8 data bits, no parity and 1 stop bit(s), plus the start bit. Find the largest number of data bytes per second it can transfer.
A 6-channel multiplexer feeds one ADC. Each conversion takes 5 µs, and after every channel switch the input needs 0.5 µs to settle. The channels are scanned in turn without pause. Find the sampling rate fs of each channel, in kHz.
Answer: N = −73
Positional number systems: each digit is worth its value times a power of the base. In binary the places are worth 1, 2, 4, 8, 16, …; in hexadecimal 1, 16, 256, …, with A–F standing for 10–15. In 8-bit two's complement the leftmost bit is worth −128 instead of +128, which is how negative numbers are stored.
The other bits keep their normal positive values.
Answer: N = −524288
Positional number systems: each digit is worth its value times a power of the base. In binary the places are worth 1, 2, 4, 8, 16, …; in hexadecimal 1, 16, 256, …, with A–F standing for 10–15. In 8-bit two's complement the leftmost bit is worth −128 instead of +128, which is how negative numbers are stored.
Answer: L = 6
Boolean algebra: the rules that simplify expressions are X + X′ = 1 and X·X′ = 0, X + X = X, absorption X + X·Y = X, the combining rule X·Y + X·Y′ = X, X + X′Y = X + Y and the consensus theorem XY + X′Z + YZ = XY + X′Z. De Morgan's laws turn (X·Y)′ into X′ + Y′ and (X + Y)′ into X′·Y′. A Karnaugh map applies these rules graphically: every group of two neighbouring cells is one use of XY + XY′ = X.
Another grouping of the same size exists; it has the same number of literals.
Answer: Q = 5
Flip-flops and counters: a flip-flop changes only at the active clock edge. D copies its input (Q⁺ = D); T toggles when T = 1; JK holds for 00, resets for 01, sets for 10 and toggles for 11. An n-bit binary counter has 2ⁿ states and counts modulo 2ⁿ; a mod-N counter goes 0, 1, …, N − 1 and back to 0, and needs the smallest n with 2ⁿ ≥ N flip-flops. Each stage of a ripple counter halves the frequency, so the last output of a mod-N counter runs at fclk/N. A Johnson counter of n flip-flops has 2n states, a ring counter n.
Answer: RB = 3840 B/s
UART: an asynchronous serial link sends each byte as a frame: one start bit (low), the data bits, an optional parity bit and one or two stop bits (high). The baud rate is the number of bits per second, so one bit lasts Tb = 1/baud and a frame of n bits lasts n/baud. The common 8N1 format has 10 bits per byte. The baud generator divides the clock: baud = fclk/(16·D) with a whole number D, so the real baud rate differs slightly from the target; an error below about 2 % is usually acceptable.
Answer: fs = 30.3 kHz
Data rates: every channel delivers fs samples per second of N bits, so the raw rate is channels × fs × N bit/s. In memory a sample takes whole bytes (a 12-bit sample is stored in 2 bytes), so the memory for a recording is channels × fs × bytes per sample × time. A multiplexed ADC converts the channels one after another: each conversion (with settling) takes t, so one round of n channels takes n·t and each channel is sampled at 1/(n·t).
ExamProblems · examproblems.com/courses/digital-electronics