Formula sheets, the key method steps for every topic and 20 practice problems, with full solutions at the back.
A car driving at 45 km/h brakes with a constant deceleration of 7 m/s² until it stops. Find the braking distance s.
A ball is thrown straight up at 8 m/s from the edge of a roof 35 m above the ground. Ignore air resistance and use g = 9.81 m/s². Find the greatest height hmax above the ground.
An 18 kg block slides down a slope at 20° to the horizontal. The coefficient of kinetic friction is 0.3. Use g = 9.81 m/s². Find the acceleration a of the block along the slope.
A 4 kg block on a ramp at 20° is connected by a light string over a frictionless pulley at the top of the ramp to a hanging 2.5 kg mass. The hanging mass moves down. The coefficient of kinetic friction between block and ramp is 0.2. Use g = 9.81 m/s². Find the acceleration a of the system.
A ball is launched from level ground at 20° above the horizontal and lands 145 m away. Ignore air resistance and use g = 9.81 m/s². Find the launch speed v0.
A ball is launched at 30° above horizontal from the top of a 40 m cliff. Ignore air resistance. Find the horizontal distance x travelled before the ball hits the ground.
In a fairground rotor, riders stand against the wall of a vertical cylinder of radius 2.6 m. When it spins fast enough the floor drops away and friction holds them up. The coefficient of static friction is 0.6. Use g = 9.81 m/s². Find the smallest angular speed ω in rad/s.
A 1.3 kg ball on a string 0.5 m long is swung in a vertical circle. At the lowest point it moves at 7 m/s. Use g = 9.81 m/s². Find the tension T in the string at the lowest point.
A 10 kg block slides 11 m down a slope at 45° to the horizontal, with a coefficient of kinetic friction of 0.35. Find the work Wf done against friction.
A 2.5 kg block is released from rest at height 5 m on a smooth ramp. At the bottom it crosses a rough horizontal strip 2.5 m long (μ = 0.3) and then runs onto a spring (k = 2500 N/m) on a smooth surface. Find the maximum compression x of the spring.
A 19 kg projectile moving horizontally at 28 m/s explodes into two fragments that move along the same line. The 5 kg fragment continues forwards at 65 m/s. Find the velocity v′2 of the 14 kg fragment (positive in the original direction).
A 0.25 kg ball hits a wall at 20 m/s and bounces straight back at 5 m/s. The contact lasts 40 ms. Find the magnitude of the impulse J the wall gives the ball.
A uniform slender rod of mass 4 kg and length 2.5 m is pinned at one end and released from rest in a horizontal position. Ignore friction and use g = 9.81 m/s². Find the angular velocity ω of the rod as it swings through the vertical position.
A uniform slender rod of mass 6 kg and length 1 m hangs at rest from a frictionless pivot at its top end. A 5 g bullet moving horizontally at 500 m/s hits the rod 0.7 m below the pivot and stays embedded. Find the angular velocity ω of the rod just after the impact.
A 3 kW motor running at 1440 rpm drives a pinion with 12 teeth, which meshes with a gear with 60 teeth. The gear pair has an efficiency of 95%. Find the torque T1 on the motor shaft.
An open belt connects a 160 mm driving pulley at 960 rpm to a 500 mm pulley; the centres are 600 mm apart. The coefficient of friction is 0.3 and the tight-side tension may not exceed 600 N. Find the largest power P the belt can transmit without slipping, in kW (ignore centrifugal effects).
An astronaut on another planet finds that a simple pendulum 1 m long has a period of 3.26 s for small swings. Find the gravitational acceleration g on that planet.
A 2.3 kg mass on a spring with k = 30 N/m is pulled 8 cm from equilibrium and released. Find the total energy E of the oscillation.
A 250 kg mass on a spring with a stiffness of 50 kN/m has a viscous damper giving a damping ratio of 0.6. Find the damped natural frequency fd of its free vibration in Hz.
A 20 kg mass hangs from two springs side by side (in parallel), with stiffnesses k₁ = 12 kN/m and k₂ = 25 kN/m. The mass stays level. Ignore damping and the masses of the springs. Find the natural frequency fn of vertical vibration in Hz.
Answer: s = 11.16 m
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Answer: hmax = 38.26 m
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Answer: a = 0.5897 m/s²
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Down the slope is positive.
Answer: a = 0.5738 m/s²
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Answer: v0 = 47.04 m/s
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Answer: x = 48.33 m
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Horizontal velocity stays constant; vertical motion has a constant acceleration g = 9.81 m/s² downward.
Solve y(t) = h + vy·t − ½gt² = 0 for the positive root.
Answer: ω = 2.508 rad/s
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Answer: T = 140.2 N
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Towards the centre (up) is positive.
Answer: Wf = 267.1 J
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
Answer: x = 28.88 cm
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
The ramp is smooth, so only the strip removes energy.
Answer: v′2 = 14.79 m/s
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: J = 6.25 N·s
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: ω = 3.431 rad/s
Rotation about a fixed axis: the sum of the moments about the axis equals I·α (ΣM = I·α), just as ΣF = m·a for translation. In energy form, a torque T turning through an angle θ (in radians) does work T·θ, which changes the kinetic energy ½·I·ω²; gravity adds or removes m·g·Δh of the centre of mass. Power is P = T·ω.
Answer: ω = 0.8739 rad/s
Rolling and angular momentum: a body rolling without slipping has v = ω·r, so its kinetic energy is ½·m·v² + ½·I·ω² = ½·m·v²·(1 + I/(m·r²)). Down a slope that gives a = g·sin θ/(1 + I/(m·r²)). When no external moment acts about an axis, the angular momentum about that axis stays constant, I₁·ω₁ = I₂·ω₂, even if kinetic energy is lost.
The pivot force passes through the pivot, so it has no moment there during the impact.
Answer: T1 = 19.89 N·m
Gear trains: meshing gears have the same speed at the teeth, so n₁·N₁ = n₂·N₂: the gear with fewer teeth turns faster. Gears on one shaft turn at the same speed. Power is passed on (minus losses), so torque goes up when speed goes down: T₂ = T₁·(N₂/N₁)·η, and P = T·ω with ω = 2π·n/60.
Answer: P = 2.591 kW
Belt drives: without slip, both pulleys have the same rim speed v = π·d·n/60, so n₁·d₁ = n₂·d₂ and the speed ratio is d₂/d₁. Slip s makes the driven pulley a little slower: n₂ = n₁·(d₁/d₂)·(1 − s). The power transmitted is P = (T₁ − T₂)·v, with T₁ the tension on the tight side and T₂ on the slack side. Friction limits the ratio of the tensions: T₁/T₂ = eμθ, where θ is the angle of wrap in radians on the smaller pulley; for an open belt θ = π − 2·asin((d₂ − d₁)/(2C)) with centre distance C.
Answer: g = 3.715 m/s²
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: E = 0.096 J
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: fd = 1.801 Hz
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Answer: fn = 6.846 Hz
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Springs side by side share the deflection and add their forces, so their stiffnesses simply add: k = k1 + k2.
ExamProblems · examproblems.com/courses/dynamics