Formula sheets, the key method steps for every topic and 20 practice problems, with full solutions at the back.
A car driving at 108 km/h brakes with a constant deceleration of 6 m/s² until it stops. How long does braking take? Find t.
A stone is dropped from rest into a well. The splash is heard 3.7 s after the stone is released. The speed of sound is 343 m/s; ignore air resistance and use g = 9.81 m/s². Find the depth d of the well.
A box slides across a level floor with an initial speed of 4.5 m/s and comes to rest after 10 m. Use g = 9.81 m/s². Find the coefficient of kinetic friction μ.
A 2 kg block on a horizontal table is connected by a light string over a frictionless pulley to a hanging 2.5 kg mass. The coefficient of kinetic friction between block and table is 0.2. Use g = 9.81 m/s². Find the acceleration a of the system.
A ball is launched at 50° above horizontal from level ground. Ignore air resistance. Find the horizontal distance x travelled before the ball hits the ground.
A ball is launched at 25° above horizontal from the top of a 40 m cliff. Ignore air resistance. Find the horizontal distance x travelled before the ball hits the ground.
An 800 kg car drives over the top of a hump in the road at 8 m/s. The top of the hump is a circular arc of radius 100 m. Use g = 9.81 m/s². Find the normal force N of the road on the car at the top.
A small cart is released from rest on a frictionless track and runs into a vertical loop of radius 4.5 m. From what minimum height hmin above the bottom of the loop must it start to stay on the track at the top of the loop?
A 2 kg ball hangs on a light string of length 0.5 m. It is pulled aside until the string makes 90° with the vertical and released from rest. Find the tension T in the string when the ball passes the lowest point.
A 10 kg block is released from rest at height 4.5 m on a smooth ramp. At the bottom it crosses a rough horizontal strip 4.5 m long (μ = 0.2) and then runs onto a spring (k = 500 N/m) on a smooth surface. Find the maximum compression x of the spring.
A 10 g bullet is fired horizontally into a 2 kg wooden block hanging on light strings, and stays inside it. The block swings up until it is 18 cm higher than at the start. Use g = 9.81 m/s². Find the speed v of the bullet before impact.
A 0.3 kg ball hits a wall at 17 m/s and bounces straight back at 4 m/s. The contact lasts 10 ms. Find the average force Favg of the wall on the ball.
A uniform slender rod of mass 7 kg and length 2.2 m is pinned at one end and held horizontal. It is released from rest. Use g = 9.81 m/s². Find its angular acceleration α just after release.
A solid sphere rolls without slipping down a slope inclined at 40° to the horizontal. Use g = 9.81 m/s². Find the acceleration a of its centre.
A 1.1 kW motor at 1450 rpm drives a worm with 3 start(s). The worm wheel has 48 teeth and the drive has an efficiency of 55%. Find the output torque Tw on the wheel shaft.
An open belt connects a 100 mm driving pulley at 2880 rpm to a 450 mm pulley; the centres are 600 mm apart. The coefficient of friction is 0.3 and the tight-side tension may not exceed 500 N. Find the largest power P the belt can transmit without slipping, in kW (ignore centrifugal effects).
An astronaut on another planet finds that a simple pendulum 1.7 m long has a period of 1.65 s for small swings. Find the gravitational acceleration g on that planet.
A body oscillates in simple harmonic motion with period 2.1 s and amplitude 15 cm. What is the shortest time t it needs to move from its maximum displacement of 15 cm to a displacement of 12 cm?
In a free-vibration test of a damped mass–spring system, a displacement peak of 20 mm is followed one cycle later by a peak of 15.6 mm. Find the damping ratio ζ.
A 10 kg mass hangs from two springs side by side (in parallel), with stiffnesses k₁ = 100 kN/m and k₂ = 30 kN/m. The mass stays level. Find the equivalent stiffness keq of the spring system in kN/m.
Answer: t = 5 s
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Answer: d = 60.86 m
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Only the positive root is physical.
Answer: μ = 0.1032
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Answer: a = 4.578 m/s²
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Answer: x = 32.53 m
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Horizontal velocity stays constant; vertical motion has a constant acceleration g = 9.81 m/s² downward.
Starting and landing at the same height: t = 2vy/g.
Answer: x = 56.71 m
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Horizontal velocity stays constant; vertical motion has a constant acceleration g = 9.81 m/s² downward.
Solve y(t) = h + vy·t − ½gt² = 0 for the positive root.
Answer: N = 7336 N
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Towards the centre (down) is positive.
The car feels lighter: the road pushes up less than its weight.
Answer: hmin = 11.25 m
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Answer: T = 58.86 N
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d). On a circular path the net force towards the centre must equal mv²/r.
Check: T = mg(3 − 2cos θ) = 58.86 N.
Answer: x = 118.9 cm
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
The ramp is smooth, so only the strip removes energy.
Answer: v = 377.7 m/s
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: Favg = 630 N
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: α = 6.689 rad/s²
Rotation about a fixed axis: the sum of the moments about the axis equals I·α (ΣM = I·α), just as ΣF = m·a for translation. In energy form, a torque T turning through an angle θ (in radians) does work T·θ, which changes the kinetic energy ½·I·ω²; gravity adds or removes m·g·Δh of the centre of mass. Power is P = T·ω.
At the moment of release ω = 0, so there is no centripetal acceleration and the centre accelerates straight down.
Answer: a = 4.504 m/s²
Rolling and angular momentum: a body rolling without slipping has v = ω·r, so its kinetic energy is ½·m·v² + ½·I·ω² = ½·m·v²·(1 + I/(m·r²)). Down a slope that gives a = g·sin θ/(1 + I/(m·r²)). When no external moment acts about an axis, the angular momentum about that axis stays constant, I₁·ω₁ = I₂·ω₂, even if kinetic energy is lost.
Answer: Tw = 63.75 N·m
Gear trains: meshing gears have the same speed at the teeth, so n₁·N₁ = n₂·N₂: the gear with fewer teeth turns faster. Gears on one shaft turn at the same speed. Power is passed on (minus losses), so torque goes up when speed goes down: T₂ = T₁·(N₂/N₁)·η, and P = T·ω with ω = 2π·n/60.
Answer: P = 4.031 kW
Belt drives: without slip, both pulleys have the same rim speed v = π·d·n/60, so n₁·d₁ = n₂·d₂ and the speed ratio is d₂/d₁. Slip s makes the driven pulley a little slower: n₂ = n₁·(d₁/d₂)·(1 − s). The power transmitted is P = (T₁ − T₂)·v, with T₁ the tension on the tight side and T₂ on the slack side. Friction limits the ratio of the tensions: T₁/T₂ = eμθ, where θ is the angle of wrap in radians on the smaller pulley; for an open belt θ = π − 2·asin((d₂ − d₁)/(2C)) with centre distance C.
Answer: g = 24.65 m/s²
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: t = 0.2151 s
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: ζ = 0.03951
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Answer: keq = 130 kN/m
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Springs side by side share the deflection and add their forces, so their stiffnesses simply add: k = k1 + k2.
ExamProblems · examproblems.com/courses/dynamics