Formula sheets, the key method steps for every topic and 20 practice problems, with full solutions at the back.
A car driving at 36 km/h brakes with a constant deceleration of 5 m/s² until it stops. Find the braking distance s.
A ball is thrown straight up at 7 m/s from the edge of a roof 10 m above the ground. Ignore air resistance and use g = 9.81 m/s². Find the greatest height hmax above the ground.
A 20 kg box is pushed up a ramp at 35° to the horizontal at constant speed, by a force parallel to the ramp. The coefficient of kinetic friction is 0.1. Use g = 9.81 m/s². Find the pushing force F.
A 7.5 kg block on a horizontal table is connected by a light string over a frictionless pulley to a hanging 0.5 kg mass. The table is frictionless. Use g = 9.81 m/s². Find the acceleration a of the system.
A ball is launched from level ground at 40° above the horizontal and lands 145 m away. Ignore air resistance and use g = 9.81 m/s². Find the launch speed v0.
A ball is thrown from ground level at 40 m/s and 70° above the horizontal. It lands on the flat roof of a building 27 m high, on its way down. Ignore air resistance and use g = 9.81 m/s². Find the horizontal distance x from the launch point to where it lands.
A car takes a flat curve of radius 55 m. The coefficient of static friction between tyres and road is 0.8. Use g = 9.81 m/s². Find the highest speed vmax at which the car can take the curve without skidding.
A small cart is released from rest on a frictionless track and runs into a vertical loop of radius 10 m. From what minimum height hmin above the bottom of the loop must it start to stay on the track at the top of the loop?
A 0.2 kg ball hangs on a light string of length 1 m. It is pulled aside until the string makes 50° with the vertical and released from rest. Find the tension T in the string when the ball passes the lowest point.
A spring of stiffness 1000 N/m at the bottom of a 30° slope is compressed by 12 cm against a 3 kg block and released. The coefficient of kinetic friction between block and slope is 0.15. How far d up the slope does the block travel from the release point before it stops? (Ignore the short distance over which the spring pushes, i.e. take friction and gravity over the whole distance d.)
A 15 kg projectile moving horizontally at 9 m/s explodes into two fragments that move along the same line. The 5 kg fragment continues forwards at 40 m/s. Find the velocity v′2 of the 10 kg fragment (positive in the original direction).
A 1300 kg car runs into a parked 1300 kg car. The wrecks lock together and skid 14.5 m before stopping. The coefficient of kinetic friction between tyres and road is 0.5. Use g = 9.81 m/s². Find the speed v1 of the first car just before the collision.
A motor delivers a torque of 560 N·m at 1200 rpm. Find its power output P in kW.
A solid cylinder starts from rest and rolls without slipping down a slope inclined at 35° to the horizontal. Use g = 9.81 m/s². Its radius is 0.25 m. Find its angular velocity ω after it has rolled 5.5 m along the slope.
Two parallel shafts are 120 mm apart. They must be connected by a pair of spur gears with a module of 4 mm and a speed reduction of 2 : 1. How many teeth N2 must the gear have?
An open belt connects a 200 mm driving pulley at 1440 rpm to a 250 mm pulley; the centres are 1200 mm apart. The coefficient of friction is 0.25 and the tight-side tension may not exceed 600 N. Find the largest power P the belt can transmit without slipping, in kW (ignore centrifugal effects).
A 3 kg mass on a spring with k = 90 N/m oscillates on a frictionless surface with an amplitude of 7 cm. Find its speed v when it is 2 cm from equilibrium.
An 8 g bullet moving at 150 m/s hits and stays in a 0.5 kg block resting on a frictionless surface. The block is attached to a horizontal spring with k = 1800 N/m. Find the amplitude A of the resulting oscillation in cm.
In a free-vibration test of a damped mass–spring system, a displacement peak of 12 mm is followed 3 cycles later by a peak of 3.9 mm. Find the damping ratio ζ.
A 100 kg mass hangs from two springs connected end to end (in series): the upper spring has k₁ = 50 kN/m and the lower one k₂ = 100 kN/m. Ignore damping and the masses of the springs. Find the natural frequency fn of vertical vibration in Hz.
Answer: s = 10 m
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Answer: hmax = 12.5 m
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Answer: F = 128.6 N
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Constant speed: the forces balance.
Answer: a = 0.6131 m/s²
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Answer: v0 = 38.01 m/s
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Answer: x = 93.86 m
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Larger root: the ball is descending.
Answer: vmax = 20.78 m/s
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Answer: hmin = 25 m
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Answer: T = 3.364 N
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d). On a circular path the net force towards the centre must equal mv²/r.
Check: T = mg(3 − 2cos θ) = 3.364 N.
Answer: d = 0.3884 m
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
Answer: v′2 = −6.5 m/s
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
The minus sign means the second fragment flies backwards.
Answer: v1 = 23.85 m/s
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: P = 70.37 kW
Rotation about a fixed axis: the sum of the moments about the axis equals I·α (ΣM = I·α), just as ΣF = m·a for translation. In energy form, a torque T turning through an angle θ (in radians) does work T·θ, which changes the kinetic energy ½·I·ω²; gravity adds or removes m·g·Δh of the centre of mass. Power is P = T·ω.
Answer: ω = 25.69 rad/s
Rolling and angular momentum: a body rolling without slipping has v = ω·r, so its kinetic energy is ½·m·v² + ½·I·ω² = ½·m·v²·(1 + I/(m·r²)). Down a slope that gives a = g·sin θ/(1 + I/(m·r²)). When no external moment acts about an axis, the angular momentum about that axis stays constant, I₁·ω₁ = I₂·ω₂, even if kinetic energy is lost.
Rolling without slipping: ω = v/r, and friction does no work at the contact point.
Answer: N2 = 40
Gear geometry: the module m sets the tooth size. A gear with N teeth has a pitch diameter d = m·N, two meshing gears have the same module, and their centre distance is a = (d₁ + d₂)/2 = m·(N₁ + N₂)/2. The pitch-line speed is v = π·d·n/60, and the tangential tooth force follows from the torque: Ft = 2T/d.
Answer: P = 4.879 kW
Belt drives: without slip, both pulleys have the same rim speed v = π·d·n/60, so n₁·d₁ = n₂·d₂ and the speed ratio is d₂/d₁. Slip s makes the driven pulley a little slower: n₂ = n₁·(d₁/d₂)·(1 − s). The power transmitted is P = (T₁ − T₂)·v, with T₁ the tension on the tight side and T₂ on the slack side. Friction limits the ratio of the tensions: T₁/T₂ = eμθ, where θ is the angle of wrap in radians on the smaller pulley; for an open belt θ = π − 2·asin((d₂ − d₁)/(2C)) with centre distance C.
Answer: v = 0.3674 m/s
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: A = 3.968 cm
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: ζ = 0.05952
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Answer: fn = 2.906 Hz
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Springs in series share the same force and add their deflections, so they combine as reciprocals: 1/k = 1/k1 + 1/k2.
ExamProblems · examproblems.com/courses/dynamics