Formula sheets, the key method steps for every topic and 20 practice problems, with full solutions at the back.
A car driving at 90 km/h brakes with a constant deceleration of 7.5 m/s² until it stops. Find the braking distance s.
Ball A is dropped from rest from a height of 10 m. At the same instant ball B is thrown straight up from the ground directly below at 21 m/s. Ignore air resistance and use g = 9.81 m/s². When do the balls meet? Find t.
A 15 kg block slides down a slope at 45° to the horizontal. The coefficient of kinetic friction is 0.2. Use g = 9.81 m/s². Find the acceleration a of the block along the slope.
A 5.5 kg block on a ramp at 20° is connected by a light string over a frictionless pulley at the top of the ramp to a hanging 10 kg mass. The hanging mass moves down. The coefficient of kinetic friction between block and ramp is 0.15. Use g = 9.81 m/s². Find the tension T in the string.
A ball is launched at 40° above horizontal from level ground. Ignore air resistance. Find the time of flight t until the ball hits the ground.
A ball is launched at 55° above horizontal from the top of a 20 m cliff. Ignore air resistance. Find the horizontal distance x travelled before the ball hits the ground.
In a fairground rotor, riders stand against the wall of a vertical cylinder of radius 1.8 m. When it spins fast enough the floor drops away and friction holds them up. The coefficient of static friction is 0.8. Use g = 9.81 m/s². Find the smallest angular speed ω in rad/s.
A 1.8 kg ball on a string 1.4 m long is swung in a vertical circle. At the lowest point it moves at 6 m/s. Use g = 9.81 m/s². Find the tension T in the string at the lowest point.
An 800 kg car drives up a 6° slope at a constant 72 km/h. Air resistance and rolling resistance together amount to 750 N. Find the power P the wheels must deliver, in kW.
A 2.5 kg block is released from rest at height 2 m on a smooth ramp. At the bottom it crosses a rough horizontal strip 5 m long (μ = 0.15) and then runs onto a spring (k = 2000 N/m) on a smooth surface. Find the maximum compression x of the spring.
A 12 g bullet is fired horizontally into a 1.5 kg wooden block hanging on light strings, and stays inside it. The block swings up until it is 13 cm higher than at the start. Use g = 9.81 m/s². Find the speed v of the bullet before impact.
A 0.25 kg ball hits a wall at 17 m/s and bounces straight back at 4 m/s. The contact lasts 10 ms. Find the average force Favg of the wall on the ball.
An 8 kg block hangs from a light cord wrapped around a pulley, a uniform solid disc of mass 3.5 kg and radius 0.45 m that turns on a frictionless horizontal axle. The block is released from rest. Use g = 9.81 m/s². Find the tension T in the cord.
A person stands on a frictionless turntable and holds a 3.5 kg dumbbell in each hand, 0.75 m from the axis. The person and turntable alone have a moment of inertia of 3 kg·m² about the axis. They turn at 40 rpm, then pull the dumbbells in to 0.2 m from the axis. Treat the dumbbells as point masses. Find the new speed n2 in rpm.
Two parallel shafts are 140 mm apart. They must be connected by a pair of spur gears with a module of 4 mm and a speed reduction of 2.5 : 1. How many teeth N2 must the gear have?
A 1.1 kW motor at 2900 rpm drives gear A (18 teeth), which meshes with gear B (50 teeth). Gear C (32 teeth) on the same shaft as B drives gear D (45 teeth) on the output shaft. Each gear mesh has an efficiency of 95%. Find the output torque Tout.
An astronaut on another planet finds that a simple pendulum 0.6 m long has a period of 2.53 s for small swings. Find the gravitational acceleration g on that planet.
A mass on a spring with k = 200 N/m oscillates on a frictionless surface with an amplitude of 11 cm. Find the energy U stored in the spring when the mass is 6 cm from equilibrium.
A 20 kg mass is supported by a spring with a stiffness of 20 kN/m and a viscous damper with a damping coefficient of 380 N·s/m. Find the damping ratio ζ.
A 20 kg mass hangs from spring k₃ = 40 kN/m. The top of k₃ is attached to a rigid bar that hangs from two springs side by side, k₁ = 10 kN/m and k₂ = 15 kN/m; the bar stays level. Ignore damping and the masses of the springs and bar. Find the natural frequency fn of vertical vibration in Hz.
Answer: s = 41.67 m
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Answer: t = 0.4762 s
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Up is positive, the ground is y = 0.
Answer: a = 5.549 m/s²
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Down the slope is positive.
Answer: T = 51.62 N
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Answer: t = 3.931 s
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Horizontal velocity stays constant; vertical motion has a constant acceleration g = 9.81 m/s² downward.
Starting and landing at the same height: t = 2vy/g.
Answer: x = 28.12 m
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Horizontal velocity stays constant; vertical motion has a constant acceleration g = 9.81 m/s² downward.
Solve y(t) = h + vy·t − ½gt² = 0 for the positive root.
Answer: ω = 2.61 rad/s
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Answer: T = 63.94 N
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Towards the centre (up) is positive.
Answer: P = 31.41 kW
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d). Power is force times speed: P = F·v.
Answer: x = 17.51 cm
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
The ramp is smooth, so only the strip removes energy.
Answer: v = 201.2 m/s
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: Favg = 525 N
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: T = 14.09 N
Rotation about a fixed axis: the sum of the moments about the axis equals I·α (ΣM = I·α), just as ΣF = m·a for translation. In energy form, a torque T turning through an angle θ (in radians) does work T·θ, which changes the kinetic energy ½·I·ω²; gravity adds or removes m·g·Δh of the centre of mass. Power is P = T·ω.
Answer: n2 = 84.6 rpm
Rolling and angular momentum: a body rolling without slipping has v = ω·r, so its kinetic energy is ½·m·v² + ½·I·ω² = ½·m·v²·(1 + I/(m·r²)). Down a slope that gives a = g·sin θ/(1 + I/(m·r²)). When no external moment acts about an axis, the angular momentum about that axis stays constant, I₁·ω₁ = I₂·ω₂, even if kinetic energy is lost.
The kinetic energy increases: the extra energy comes from the work the person does pulling the dumbbells in.
Answer: N2 = 50
Gear geometry: the module m sets the tooth size. A gear with N teeth has a pitch diameter d = m·N, two meshing gears have the same module, and their centre distance is a = (d₁ + d₂)/2 = m·(N₁ + N₂)/2. The pitch-line speed is v = π·d·n/60, and the tangential tooth force follows from the torque: Ft = 2T/d.
Answer: Tout = 12.77 N·m
Gear trains: meshing gears have the same speed at the teeth, so n₁·N₁ = n₂·N₂: the gear with fewer teeth turns faster. Gears on one shaft turn at the same speed. Power is passed on (minus losses), so torque goes up when speed goes down: T₂ = T₁·(N₂/N₁)·η, and P = T·ω with ω = 2π·n/60.
Answer: g = 3.701 m/s²
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: U = 0.36 J
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: ζ = 0.3004
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
ζ < 1, so the system is underdamped and oscillates as it decays.
Answer: fn = 4.414 Hz
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Only k1 and k2 are in parallel. That pair is in series with k3, so combine them as reciprocals.
ExamProblems · examproblems.com/courses/dynamics