Formula sheets, the key method steps for every topic and 20 practice problems, with full solutions at the back.
A car driving at 120 km/h brakes with a constant deceleration of 8 m/s² until it stops. How long does braking take? Find t.
A ball is thrown straight up at 6 m/s from the edge of a roof 35 m above the ground. Ignore air resistance and use g = 9.81 m/s². How long after the throw does it hit the ground? Find t.
An 8 kg block slides down a slope at 20° to the horizontal. The coefficient of kinetic friction is 0.25. Use g = 9.81 m/s². Find the acceleration a of the block along the slope.
A 2 kg block on a ramp at 30° is connected by a light string over a frictionless pulley at the top of the ramp to a hanging 7.5 kg mass. The hanging mass moves down. The coefficient of kinetic friction between block and ramp is 0.1. Use g = 9.81 m/s². Find the tension T in the string.
A ball is launched from level ground at 28 m/s and must land 30 m away. Ignore air resistance and use g = 9.81 m/s². Find the smaller of the two possible launch angles θ.
A ball is launched at 11 m/s and 45° above the horizontal from the top of a 45 m cliff. Ignore air resistance and use g = 9.81 m/s². Find the greatest height H above the ground at the foot of the cliff.
In a fairground rotor, riders stand against the wall of a vertical cylinder of radius 2.6 m. When it spins fast enough the floor drops away and friction holds them up. The coefficient of static friction is 0.8. Use g = 9.81 m/s². Find the smallest angular speed ω in rad/s.
A curve of radius 300 m is banked at 10°, and the coefficient of static friction between tyres and road is 0.25. Use g = 9.81 m/s². Find the highest speed vmax at which a car can take the curve without sliding up and out.
A toy launcher has a vertical spring of stiffness 400 N/m. A 0.05 kg ball is placed on it and the spring is compressed by 4 cm, then released. Ignoring air resistance and the spring’s mass, find the height h the ball rises, measured from its position when the spring was compressed.
A 10 kg block is released from rest at height 5 m on a smooth ramp. At the bottom it crosses a rough horizontal strip 1 m long (μ = 0.3) and then runs onto a spring (k = 4000 N/m) on a smooth surface. Find the maximum compression x of the spring.
A 1900 kg car moving at 11 m/s runs into a stationary 2000 kg car and the two lock together. How much kinetic energy ΔK is lost in the collision?
At a crossing a 1100 kg car travelling east at 14 m/s collides with a 1500 kg car travelling north at 11 m/s. The cars lock together. Find the speed v′ of the wreck just after the collision.
A flywheel with a moment of inertia of 18 kg·m² spins at 1800 rpm. A brake applies a constant friction torque of 55 N·m. How many revolutions N does the flywheel make before it stops?
A hollow sphere rolls without slipping down a slope inclined at 20° to the horizontal. Use g = 9.81 m/s². Find the smallest coefficient of static friction μs that prevents it from slipping.
A 4 kW motor running at 1450 rpm drives a pinion with 24 teeth, which meshes with a gear with 30 teeth. The gear pair has an efficiency of 96%. Find the output torque T2 on the gear shaft.
An 11 kW motor at 1450 rpm drives gear A (32 teeth), which meshes with gear B (36 teeth). Gear C (25 teeth) on the same shaft as B drives gear D (48 teeth) on the output shaft. Each gear mesh has an efficiency of 96%. Find the output torque Tout.
How long must a simple pendulum be to have a period of 2.2 s? Use g = 9.81 m/s². Find L.
A body oscillates in simple harmonic motion with period 3 s and amplitude 16 cm. What is the shortest time t it needs to move from equilibrium to a displacement of 8 cm?
A 50 kg mass is supported by a spring with a stiffness of 100 kN/m and a viscous damper with a damping coefficient of 450 N·s/m. Find the damping ratio ζ.
A 40 kg mass hangs from two springs connected end to end (in series): the upper spring has k₁ = 5 kN/m and the lower one k₂ = 10 kN/m. Find the equivalent stiffness keq of the spring system in kN/m.
Answer: t = 4.167 s
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Answer: t = 3.352 s
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Up is positive and the ground is h₀ below the starting point.
Only the positive root is physical.
Answer: a = 1.051 m/s²
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Down the slope is positive.
Answer: T = 24.58 N
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Answer: θ = 11.02 °
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
The other solution is 90° − θ = 78.98°.
Answer: H = 48.08 m
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Answer: ω = 2.172 rad/s
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Answer: vmax = 36.23 m/s
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Friction points down the slope.
Answer: h = 0.6524 m
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
Answer: x = 48.01 cm
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
The ramp is smooth, so only the strip removes energy.
Answer: ΔK = 58949 J
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
The lost energy goes into deformation, heat and sound.
Answer: v′ = 8.681 m/s
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: N = 925.3 rev
Rotation about a fixed axis: the sum of the moments about the axis equals I·α (ΣM = I·α), just as ΣF = m·a for translation. In energy form, a torque T turning through an angle θ (in radians) does work T·θ, which changes the kinetic energy ½·I·ω²; gravity adds or removes m·g·Δh of the centre of mass. Power is P = T·ω.
Answer: μs = 0.1456
Rolling and angular momentum: a body rolling without slipping has v = ω·r, so its kinetic energy is ½·m·v² + ½·I·ω² = ½·m·v²·(1 + I/(m·r²)). Down a slope that gives a = g·sin θ/(1 + I/(m·r²)). When no external moment acts about an axis, the angular momentum about that axis stays constant, I₁·ω₁ = I₂·ω₂, even if kinetic energy is lost.
Answer: T2 = 31.61 N·m
Gear trains: meshing gears have the same speed at the teeth, so n₁·N₁ = n₂·N₂: the gear with fewer teeth turns faster. Gears on one shaft turn at the same speed. Power is passed on (minus losses), so torque goes up when speed goes down: T₂ = T₁·(N₂/N₁)·η, and P = T·ω with ω = 2π·n/60.
Answer: Tout = 144.2 N·m
Gear trains: meshing gears have the same speed at the teeth, so n₁·N₁ = n₂·N₂: the gear with fewer teeth turns faster. Gears on one shaft turn at the same speed. Power is passed on (minus losses), so torque goes up when speed goes down: T₂ = T₁·(N₂/N₁)·η, and P = T·ω with ω = 2π·n/60.
Answer: L = 1.203 m
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: t = 0.25 s
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: ζ = 0.1006
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
ζ < 1, so the system is underdamped and oscillates as it decays.
Answer: keq = 3.333 kN/m
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Springs in series share the same force and add their deflections, so they combine as reciprocals: 1/k = 1/k1 + 1/k2.
ExamProblems · examproblems.com/courses/dynamics