Formula sheets, the key method steps for every topic and 4 practice problems, with full solutions at the back.
Practice exercise (made-up values, not clinical guidance). The record shows a patient's intake and output for one 12-hour shift. The patient weighs 70 kg. Find the average urine output U in mL/kg/h. Round to two decimal places.
Practice exercise (made-up values, not clinical guidance). A 1000 mL bag runs by pump at 120 mL/h. At 10:00, 150 mL have already been infused. How many hours t until the bag is empty? Round to one decimal place.
1500 mL was ordered over 12 hours. After 6 hours you find that 890 mL is still in the bag, and the order must still finish on time. To what rate R in mL/h must the pump be reset?
An infusion of 100 mg in 250 mL runs at 3 mL/h. How many micrograms per minute D does the patient receive?
Answer: U = 1.43 mL/kg/h
Intake and output: intake counts everything that goes in (oral fluids, IV infusions, IV medications and flushes, tube feeds); ice chips count as half their volume. Output counts urine, drains, vomit and other losses. Balance = total intake − total output; a negative balance is a net loss. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: t = 7.1 h
Infusion time: time (h) = volume to infuse (mL)/rate (mL/h); use the volume still left in the bag, not the bag size. Volume infused = rate × time. Convert decimal hours to hours and minutes with the fraction × 60 (0.5 h = 30 min, not 50 min). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
That is about 7 h 05 min, so the bag runs out at about 17:05.
Answer: R = 148.3 mL/h
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Many hospitals allow such an adjustment up to 25% without a new order; check local policy.
Answer: D = 20 mcg/min
Dose-based infusions: concentration = amount of drug in the bag/bag volume. Pump rate (mL/h) = dose per hour/concentration, and dose per hour = mL/h × concentration. Convert per-minute doses to per-hour (× 60) and keep the mass units the same (1 g = 1000 mg, 1 mg = 1000 mcg).
ExamProblems · examproblems.com/courses/iv-fluids-and-fluid-balance