Formula sheets, the key method steps for every topic and 4 practice problems, with full solutions at the back.
Practice exercise (made-up values, not clinical guidance). The record shows a patient's intake and output for one 8-hour shift. The IV infusion ran at the rate shown for the whole shift. Find the fluid balance B = intake − output in mL (a negative answer means a net loss).
Practice exercise (made-up values, not clinical guidance). A 1000 mL infusion starts at 17:30 at 125 mL/h. After 2 hours the rate is changed to 60 mL/h and is not changed again. How many hours t after the start will the bag be empty? Round to one decimal place.
A drip runs at 20 gtt/min through a set of 20 gtt/mL. How many millilitres V does the patient receive in 2 hours?
1000 mL was ordered over 6 hours. After 3 hours you find that 630 mL is still in the bag, and the order must still finish on time. By what percentage Δ must the original pump rate be increased?
Answer: B = −520 mL
Intake and output: intake counts everything that goes in (oral fluids, IV infusions, IV medications and flushes, tube feeds); ice chips count as half their volume. Output counts urine, drains, vomit and other losses. Balance = total intake − total output; a negative balance is a net loss. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Negative: the patient lost more fluid than went in.
Answer: t = 14.5 h
Infusion time: time (h) = volume to infuse (mL)/rate (mL/h); use the volume still left in the bag, not the bag size. Volume infused = rate × time. Convert decimal hours to hours and minutes with the fraction × 60 (0.5 h = 30 min, not 50 min). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
That is about 14 h 30 min, so the bag runs out at about 08:00.
Answer: V = 120 mL
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Answer: Δ = 26 %
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
This is more than a 25% increase: most hospitals require you to contact the prescriber instead of catching up, and to assess the patient for fluid overload.
ExamProblems · examproblems.com/courses/iv-fluids-and-fluid-balance