Formula sheets, the key method steps for every topic and 4 practice problems, with full solutions at the back.
Practice exercise (made-up values, not clinical guidance). The record shows a patient's intake and output for one 8-hour shift. The IV infusion ran at the rate shown for the whole shift. Find the fluid balance B = intake − output in mL (a negative answer means a net loss). Count ice chips as half their volume.
Practice exercise (made-up values, not clinical guidance). A 500 mL bag runs by pump at 80 mL/h. At 20:00, 300 mL have already been infused. How many hours t until the bag is empty? Round to one decimal place.
500 mL was ordered over 6 hours. After 3 hours you find that 300 mL is still in the bag, and the order must still finish on time. To what rate R in mL/h must the pump be reset?
A bag contains 250 mg of a drug in 100 mL and runs at 8 mL/h. How many milligrams per hour D does the patient receive?
Answer: B = 180 mL
Intake and output: intake counts everything that goes in (oral fluids, IV infusions, IV medications and flushes, tube feeds); ice chips count as half their volume. Output counts urine, drains, vomit and other losses. Balance = total intake − total output; a negative balance is a net loss. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Positive: more fluid went in than came out.
Answer: t = 2.5 h
Infusion time: time (h) = volume to infuse (mL)/rate (mL/h); use the volume still left in the bag, not the bag size. Volume infused = rate × time. Convert decimal hours to hours and minutes with the fraction × 60 (0.5 h = 30 min, not 50 min). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
That is about 2 h 30 min, so the bag runs out at about 22:30.
Answer: R = 100 mL/h
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Many hospitals allow such an adjustment up to 25% without a new order; check local policy.
Answer: D = 20 mg/h
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
ExamProblems · examproblems.com/courses/iv-fluids-and-fluid-balance