Formula sheets, the key method steps for every topic and 4 practice problems, with full solutions at the back.
Practice exercise (made-up values, not clinical guidance). The record shows a patient's intake and output for one 8-hour shift. The IV infusion ran at the rate shown for the whole shift. Find the fluid balance B = intake − output in mL (a negative answer means a net loss). Count ice chips as half their volume.
Practice exercise (made-up values, not clinical guidance). A 500 mL infusion starts at 09:30 at 75 mL/h. After 2 hours the rate is changed to 150 mL/h and is not changed again. How many hours t after the start will the bag be empty? Round to one decimal place.
Infuse 250 mL over 10 hours with a giving set of 20 gtt/mL. Find the drip rate R in drops per minute. Round to the nearest whole number.
An infusion of 50 mg in 500 mL runs at 12 mL/h. How many micrograms per minute D does the patient receive?
Answer: B = 965 mL
Intake and output: intake counts everything that goes in (oral fluids, IV infusions, IV medications and flushes, tube feeds); ice chips count as half their volume. Output counts urine, drains, vomit and other losses. Balance = total intake − total output; a negative balance is a net loss. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Positive: more fluid went in than came out.
Answer: t = 4.3 h
Infusion time: time (h) = volume to infuse (mL)/rate (mL/h); use the volume still left in the bag, not the bag size. Volume infused = rate × time. Convert decimal hours to hours and minutes with the fraction × 60 (0.5 h = 30 min, not 50 min). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
That is about 4 h 20 min, so the bag runs out at about 13:50.
Answer: R = 8 gtt/min
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
At the bedside you round to the nearest whole drop: 8 gtt/min.
Answer: D = 20 mcg/min
Dose-based infusions: concentration = amount of drug in the bag/bag volume. Pump rate (mL/h) = dose per hour/concentration, and dose per hour = mL/h × concentration. Convert per-minute doses to per-hour (× 60) and keep the mass units the same (1 g = 1000 mg, 1 mg = 1000 mcg).
ExamProblems · examproblems.com/courses/iv-fluids-and-fluid-balance