In the print window, choose “Save as PDF” to keep a copy on your device.
1Formulas and methods
Maternity & obstetric nursing
Method
Place the woman in time: weeks of pregnancy, stage of labour or day after birth, and decide what is normal at that point.
Look for the patient in danger: the mother, the fetus or the newborn, or more than one of them.
Link the finding to its cause: VEAL CHOP for decelerations, the four Ts for bleeding, BUBBLE-HE after birth.
Choose the action that improves blood flow and oxygen first (side-lying, stopping oxytocin, fundal massage), then escalate.
Dosage calculations
Dose from strength
volume = dose / strength
Weight-based dose
dose = mg/kg × body weight
Tablets
number = dose / tablet strength
Units
1 g = 1000 mg, 1 mg = 1000 mcg
Method
Convert the ordered dose and the stock strength to the same unit.
Use desired over have times quantity: (D/H) × Q.
For weight-based doses, multiply by the weight in kg first, then divide the daily dose by the number of doses.
Estimate first and check that the answer is reasonable.
IV infusion rates
Pump rate
mL/h = volume (mL)/time (h)
Drip rate
drops/min = volume (mL) × drop factor / time (min)
Infusion time
time (h) = volume (mL)/rate (mL/h)
Method
Pump rate in mL/h: volume divided by time in hours.
Drip rate in drops/min: volume × drop factor divided by time in minutes.
For time remaining: volume left divided by the rate.
Round as the question or the equipment requires.
2Practice problems
1.Maternity & obstetric nursingMedium
Why is congenital hypothyroidism included in newborn screening?
AEarly treatment prevents brain damage
BIt causes hip dysplasia
CIt can only be treated before birth
DIt causes jaundice that cannot be treated
2.Maternity & obstetric nursingHard
A pregnant woman involved in a car crash asks how to wear a seat belt. Which instruction is correct?
APut the lap belt across the top of the bump, above the uterus
BLap belt under the bump, shoulder belt between the breasts
CWear only the shoulder part of the belt
DDo not wear a seat belt in pregnancy
3.Dosage calculationsMedium
An ampoule of epinephrine (adrenaline) is labelled 1:1000 (1 mg/mL). The prescription is 0.5 mg IM for anaphylaxis. What volume V do you draw up?
1:10000.5 mg
V = mL
4.Dosage calculationsHard
An infusion contains 20000 units of a drug in 1000 mL. The prescription is 1000 units per hour. At what rate R do you set the pump, in mL/h?
20000 units/1000 mL1000 units/h
R = mL/h
5.IV infusion ratesMedium
A drip runs at 40 gtt/min through a set of 15 gtt/mL. How many millilitres V does the patient receive in 3 hours?
40 gtt/min15 gtt/mL3 h
V = mL
6.IV infusion ratesHard
1500 mL was ordered over 10 hours. After 4 hours you find that 1010 mL is still in the bag, and the order must still finish on time. By what percentage Δ must the original pump rate be increased?
1500 mL / 10 hafter 4 h: 1010 mL
Δ = %
3Solutions
1.Maternity & obstetric nursing
Answer: A · Early treatment prevents brain damage
Why this is the answer
Untreated congenital hypothyroidism causes poor growth and intellectual disability. Daily levothyroxine started in the first weeks allows normal development.
Answer
A · Early treatment prevents brain damage
2.Maternity & obstetric nursing
Answer: B · Lap belt under the bump, shoulder belt between the breasts
Why this is the answer
The lap belt should sit low under the abdomen across the hips and thighs, with the shoulder belt across the chest and to the side of the bump. Wearing a seat belt greatly reduces maternal and fetal injury.
Answer
B · Lap belt under the bump, shoulder belt between the breasts
3.Dosage calculations
Answer: V = 0.5 mL
Solution strengths: a percentage strength is grams per 100 mL, so 1% = 1 g/100 mL = 10 mg/mL. A ratio strength 1:1000 means 1 g in 1000 mL = 1 mg/mL; 1:10 000 is 0.1 mg/mL. For a dilution the amount of drug stays the same: C₁·V₁ = C₂·V₂.
Concentration
1:1000 = 1 g/1000 mL = 1 mg/mL
Volume
V = 0.5/1 = 0.5 mL
Answer
V = 0.5 mL
US labels now state mg/mL (1 mg/mL = 1:1000; 0.1 mg/mL = 1:10 000). Never give 1 mg/mL epinephrine IV push.
4.Dosage calculations
Answer: R = 50 mL/h
Dose calculation: the amount to give equals what is prescribed divided by what you have, times the quantity it comes in: amount = (desired dose/stock strength) × stock volume. Always keep the units the same (convert g to mg, mg to mcg first) and check that the answer is sensible.
Concentration
20000/1000 = 20 units/mL
Pump rate
R = 1000/20 = 50 mL/h
Answer
R = 50 mL/h
5.IV infusion rates
Answer: V = 480 mL
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Rate in mL/h
40·60/15 = 160 mL/h
Volume
V = 160·3 = 480 mL
Answer
V = 480 mL
6.IV infusion rates
Answer: Δ = 12.22 %
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Original rate
1500/10 = 150 mL/h
New rate
R = 1010/6 = 168.3 mL/h
Percentage change
Δ = (168.3 − 150)/150·100% = 12.22%
Answer
Δ = 12.22%
Many hospitals allow such an adjustment up to 25% without a new order; check local policy.