In the print window, choose “Save as PDF” to keep a copy on your device.
1Formulas and methods
Maternity & obstetric nursing
Method
Place the woman in time: weeks of pregnancy, stage of labour or day after birth, and decide what is normal at that point.
Look for the patient in danger: the mother, the fetus or the newborn, or more than one of them.
Link the finding to its cause: VEAL CHOP for decelerations, the four Ts for bleeding, BUBBLE-HE after birth.
Choose the action that improves blood flow and oxygen first (side-lying, stopping oxytocin, fundal massage), then escalate.
Dosage calculations
Dose from strength
volume = dose / strength
Weight-based dose
dose = mg/kg × body weight
Tablets
number = dose / tablet strength
Units
1 g = 1000 mg, 1 mg = 1000 mcg
Method
Convert the ordered dose and the stock strength to the same unit.
Use desired over have times quantity: (D/H) × Q.
For weight-based doses, multiply by the weight in kg first, then divide the daily dose by the number of doses.
Estimate first and check that the answer is reasonable.
IV infusion rates
Pump rate
mL/h = volume (mL)/time (h)
Drip rate
drops/min = volume (mL) × drop factor / time (min)
Infusion time
time (h) = volume (mL)/rate (mL/h)
Method
Pump rate in mL/h: volume divided by time in hours.
Drip rate in drops/min: volume × drop factor divided by time in minutes.
For time remaining: volume left divided by the rate.
Round as the question or the equipment requires.
2Practice problems
1.Maternity & obstetric nursingMedium
Why is it important to do newborn bloodspot screening at the recommended time rather than in the first hours?
AThe heel cannot be pricked until the cord falls off
BEarlier testing always gives false negatives for all conditions
CThe baby's blood cannot be sampled before day 3
DSome results, such as PKU, need milk feeds first
2.Maternity & obstetric nursingHard
A woman at 40 weeks calls the unit. Her contractions are every 10 to 20 minutes and irregular, her membranes are intact and the baby is moving well. What is the best advice?
ATake a laxative to stimulate labour
BRest at home and come in if contractions become regular
CCome in immediately by ambulance
DLie flat on her back and count the contractions for 4 hours
3.Dosage calculationsMedium
A vial contains 1 g of powder. The label says: add 3.4 mL of water for injection to give a total volume of 4 mL. The prescription is 375 mg. What volume V of the reconstituted solution do you give?
1 g+ 3.4 mL → 4 mL375 mg
V = mL
4.Dosage calculationsHard
You must prepare 1000 mL of a 2% (w/v) solution from a 50% (w/v) stock solution. What volume of stock V₁ do you need?
C₁ = 50%C₂ = 2%V₂ = 1000 mL
V₁ = mL
5.IV infusion ratesMedium
1500 mL was ordered over 10 hours. After 3 hours you find that 1130 mL is still in the bag, and the order must still finish on time. To what rate R in mL/h must the pump be reset?
1500 mL / 10 hafter 3 h: 1130 mL
R = mL/h
6.IV infusion ratesHard
A bag contains 4 g of a drug in 1000 mL. The order is 4 mg per minute. At what rate R do you set the pump, in mL/h?
4 g/1000 mL4 mg/min
R = mL/h
3Solutions
1.Maternity & obstetric nursing
Answer: D · Some results, such as PKU, need milk feeds first
Why this is the answer
Phenylalanine builds up only after the baby has had milk feeds, so very early samples can miss PKU. Programmes specify timing, and early samples may need repeating.
Answer
D · Some results, such as PKU, need milk feeds first
2.Maternity & obstetric nursing
Answer: B · Rest at home and come in if contractions become regular
Why this is the answer
Irregular, infrequent contractions with intact membranes and good movements suggest early or false labour. She can rest at home and should come in if contractions become regular and stronger, the membranes rupture, she bleeds or movements decrease.
Answer
B · Rest at home and come in if contractions become regular
3.Dosage calculations
Answer: V = 1.5 mL
Dose calculation: the amount to give equals what is prescribed divided by what you have, times the quantity it comes in: amount = (desired dose/stock strength) × stock volume. Always keep the units the same (convert g to mg, mg to mcg first) and check that the answer is sensible.
Concentration after mixing
1000 mg/4 mL = 250 mg/mL
Volume
V = 375/250 = 1.5 mL
Answer
V = 1.5 mL
4.Dosage calculations
Answer: V₁ = 40 mL
Solution strengths: a percentage strength is grams per 100 mL, so 1% = 1 g/100 mL = 10 mg/mL. A ratio strength 1:1000 means 1 g in 1000 mL = 1 mg/mL; 1:10 000 is 0.1 mg/mL. For a dilution the amount of drug stays the same: C₁·V₁ = C₂·V₂.
Volume of stock
V₁ = 2·1000/50 = 40 mL
Answer
V₁ = 40 mL
5.IV infusion rates
Answer: R = 161.4 mL/h
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Original rate
1500/10 = 150 mL/h
New rate
R = 1130/7 = 161.4 mL/h
Answer
R = 161.4 mL/h
Many hospitals allow such an adjustment up to 25% without a new order; check local policy.
6.IV infusion rates
Answer: R = 60 mL/h
Dose-based infusions: concentration = amount of drug in the bag/bag volume. Pump rate (mL/h) = dose per hour/concentration, and dose per hour = mL/h × concentration. Convert per-minute doses to per-hour (× 60) and keep the mass units the same (1 g = 1000 mg, 1 mg = 1000 mcg).