In the print window, choose “Save as PDF” to keep a copy on your device.
1Formulas and methods
Maternity & obstetric nursing
Method
Place the woman in time: weeks of pregnancy, stage of labour or day after birth, and decide what is normal at that point.
Look for the patient in danger: the mother, the fetus or the newborn, or more than one of them.
Link the finding to its cause: VEAL CHOP for decelerations, the four Ts for bleeding, BUBBLE-HE after birth.
Choose the action that improves blood flow and oxygen first (side-lying, stopping oxytocin, fundal massage), then escalate.
Dosage calculations
Dose from strength
volume = dose / strength
Weight-based dose
dose = mg/kg × body weight
Tablets
number = dose / tablet strength
Units
1 g = 1000 mg, 1 mg = 1000 mcg
Method
Convert the ordered dose and the stock strength to the same unit.
Use desired over have times quantity: (D/H) × Q.
For weight-based doses, multiply by the weight in kg first, then divide the daily dose by the number of doses.
Estimate first and check that the answer is reasonable.
IV infusion rates
Pump rate
mL/h = volume (mL)/time (h)
Drip rate
drops/min = volume (mL) × drop factor / time (min)
Infusion time
time (h) = volume (mL)/rate (mL/h)
Method
Pump rate in mL/h: volume divided by time in hours.
Drip rate in drops/min: volume × drop factor divided by time in minutes.
For time remaining: volume left divided by the rate.
Round as the question or the equipment requires.
2Practice problems
1.Maternity & obstetric nursingMedium
Why is it important to do newborn bloodspot screening at the recommended time rather than in the first hours?
AThe heel cannot be pricked until the cord falls off
BEarlier testing always gives false negatives for all conditions
CSome results, such as PKU, need milk feeds first
DThe baby's blood cannot be sampled before day 3
2.Maternity & obstetric nursingHard
A student nurse is caring for a newborn receiving phototherapy for jaundice. Which action requires correction?
ARemoving the eye shields during feeds when the lights are off
BCovering the baby's eyes with eye shields during phototherapy
CChecking the baby's temperature and hydration regularly
DApplying baby oil to the skin before the lights are switched on
3.Dosage calculationsMedium
A prefilled syringe of epinephrine (adrenaline) is labelled 1:10 000 (0.1 mg/mL). The prescription is 1 mg IV in cardiac arrest. What volume V do you give?
1:10 0001 mg
V = mL
4.Dosage calculationsHard
An infusion contains 50000 units of a drug in 250 mL. The prescription is 1250 units per hour. At what rate R do you set the pump, in mL/h?
50000 units/250 mL1250 units/h
R = mL/h
5.IV infusion ratesMedium
An infusion is ordered at 80 mL/h, but no pump is available. It runs by gravity through a giving set of 15 gtt/mL. Find the drip rate R in drops per minute.
80 mL/h15 gtt/mL
R = gtt/min
6.IV infusion ratesHard
A drip runs at 30 gtt/min through a set of 15 gtt/mL. There are 200 mL left in the bag. How many hours t until it is empty? Round to one decimal place.
30 gtt/min15 gtt/mL200 mL
t = h
3Solutions
1.Maternity & obstetric nursing
Answer: C · Some results, such as PKU, need milk feeds first
Why this is the answer
Phenylalanine builds up only after the baby has had milk feeds, so very early samples can miss PKU. Programmes specify timing, and early samples may need repeating.
Answer
C · Some results, such as PKU, need milk feeds first
2.Maternity & obstetric nursing
Answer: D · Applying baby oil to the skin before the lights are switched on
Why this is the answer
Oils and lotions can cause burns under phototherapy lights and should not be applied. Eye shields protect the retina, temperature and hydration are monitored because of increased fluid loss, and feeds are an opportunity for eye contact without the shields.
Answer
D · Applying baby oil to the skin before the lights are switched on
3.Dosage calculations
Answer: V = 10 mL
Solution strengths: a percentage strength is grams per 100 mL, so 1% = 1 g/100 mL = 10 mg/mL. A ratio strength 1:1000 means 1 g in 1000 mL = 1 mg/mL; 1:10 000 is 0.1 mg/mL. For a dilution the amount of drug stays the same: C₁·V₁ = C₂·V₂.
Concentration
1:10 000 = 1 g/10000 mL = 0.1 mg/mL
Volume
V = 1/0.1 = 10 mL
Answer
V = 10 mL
US labels now state mg/mL (1 mg/mL = 1:1000; 0.1 mg/mL = 1:10 000). Never give 1 mg/mL epinephrine IV push.
4.Dosage calculations
Answer: R = 6.25 mL/h
Dose calculation: the amount to give equals what is prescribed divided by what you have, times the quantity it comes in: amount = (desired dose/stock strength) × stock volume. Always keep the units the same (convert g to mg, mg to mcg first) and check that the answer is sensible.
Concentration
50000/250 = 200 units/mL
Pump rate
R = 1250/200 = 6.25 mL/h
Answer
R = 6.25 mL/h
5.IV infusion rates
Answer: R = 20 gtt/min
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Millilitres per minute
80/60 = 1.333 mL/min
Drip rate
R = 1.333·15 = 20 gtt/min
Answer
R = 20 gtt/min
6.IV infusion rates
Answer: t = 1.7 h
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.