In the print window, choose “Save as PDF” to keep a copy on your device.
1Formulas and methods
Maternity & obstetric nursing
Method
Place the woman in time: weeks of pregnancy, stage of labour or day after birth, and decide what is normal at that point.
Look for the patient in danger: the mother, the fetus or the newborn, or more than one of them.
Link the finding to its cause: VEAL CHOP for decelerations, the four Ts for bleeding, BUBBLE-HE after birth.
Choose the action that improves blood flow and oxygen first (side-lying, stopping oxytocin, fundal massage), then escalate.
Dosage calculations
Dose from strength
volume = dose / strength
Weight-based dose
dose = mg/kg × body weight
Tablets
number = dose / tablet strength
Units
1 g = 1000 mg, 1 mg = 1000 mcg
Method
Convert the ordered dose and the stock strength to the same unit.
Use desired over have times quantity: (D/H) × Q.
For weight-based doses, multiply by the weight in kg first, then divide the daily dose by the number of doses.
Estimate first and check that the answer is reasonable.
IV infusion rates
Pump rate
mL/h = volume (mL)/time (h)
Drip rate
drops/min = volume (mL) × drop factor / time (min)
Infusion time
time (h) = volume (mL)/rate (mL/h)
Method
Pump rate in mL/h: volume divided by time in hours.
Drip rate in drops/min: volume × drop factor divided by time in minutes.
For time remaining: volume left divided by the rate.
Round as the question or the equipment requires.
2Practice problems
1.Maternity & obstetric nursingMedium
Obesity before pregnancy (BMI 40) most increases the risk of which pregnancy complication?
ALow birth weight from overnutrition
BGestational diabetes
CPlacenta praevia only
DHyperemesis gravidarum
2.Maternity & obstetric nursingHard
Why does the ductus arteriosus normally close after birth?
ARising oxygen levels and falling prostaglandins
BRising prostaglandins and falling oxygen levels
CPressure in the pulmonary artery rises
DThe cord is cut, which closes it directly
3.Dosage calculationsMedium
A patient weighing 97 kg has a body surface area of 1.85 m². The prescription is 100 mg/m². Find the dose D in mg.
97 kgBSA = 1.85 m²100 mg/m²
D = mg
4.Dosage calculationsHard
An infusion contains 20000 units of a drug in 1000 mL. The prescription is 500 units per hour. At what rate R do you set the pump, in mL/h?
20000 units/1000 mL500 units/h
R = mL/h
5.IV infusion ratesMedium
Infuse 500 mL over 5 hours with a giving set of 15 gtt/mL. Find the drip rate R in drops per minute.
500 mL5 h15 gtt/mL
R = gtt/min
6.IV infusion ratesHard
An infusion of 25 mg in 250 mL runs at 18 mL/h. How many micrograms per minute D does the patient receive?
25 mg/250 mL18 mL/h
D = mcg/min
3Solutions
1.Maternity & obstetric nursing
Answer: B · Gestational diabetes
Why this is the answer
Obesity raises the risks of gestational diabetes, pre-eclampsia, venous thromboembolism, macrosomia, caesarean birth and stillbirth. Early glucose testing and VTE risk assessment are often recommended.
Answer
B · Gestational diabetes
2.Maternity & obstetric nursing
Answer: A · Rising oxygen levels and falling prostaglandins
Why this is the answer
Higher blood oxygen and lower prostaglandin levels after birth cause the ductus arteriosus to constrict. Prostaglandin infusions are used to keep it open in duct-dependent heart defects.
Answer
A · Rising oxygen levels and falling prostaglandins
3.Dosage calculations
Answer: D = 185 mg
Body-surface-area dosing: many cytotoxic and some paediatric doses are prescribed per square metre of body surface area: dose (mg) = dose per m² × BSA (m²). The Mosteller formula estimates BSA = √(height (cm) × weight (kg)/3600).
Dose
D = 100·1.85 = 185 mg
Answer
D = 185 mg
4.Dosage calculations
Answer: R = 25 mL/h
Dose calculation: the amount to give equals what is prescribed divided by what you have, times the quantity it comes in: amount = (desired dose/stock strength) × stock volume. Always keep the units the same (convert g to mg, mg to mcg first) and check that the answer is sensible.
Concentration
20000/1000 = 20 units/mL
Pump rate
R = 500/20 = 25 mL/h
Answer
R = 25 mL/h
5.IV infusion rates
Answer: R = 25 gtt/min
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Time in minutes
5·60 = 300 min
Drip rate
R = 500·15/300 = 25 gtt/min
Answer
R = 25 gtt/min
6.IV infusion rates
Answer: D = 30 mcg/min
Dose-based infusions: concentration = amount of drug in the bag/bag volume. Pump rate (mL/h) = dose per hour/concentration, and dose per hour = mL/h × concentration. Convert per-minute doses to per-hour (× 60) and keep the mass units the same (1 g = 1000 mg, 1 mg = 1000 mcg).