In the print window, choose “Save as PDF” to keep a copy on your device.
1Formulas and methods
Maternity & obstetric nursing
Method
Place the woman in time: weeks of pregnancy, stage of labour or day after birth, and decide what is normal at that point.
Look for the patient in danger: the mother, the fetus or the newborn, or more than one of them.
Link the finding to its cause: VEAL CHOP for decelerations, the four Ts for bleeding, BUBBLE-HE after birth.
Choose the action that improves blood flow and oxygen first (side-lying, stopping oxytocin, fundal massage), then escalate.
Dosage calculations
Dose from strength
volume = dose / strength
Weight-based dose
dose = mg/kg × body weight
Tablets
number = dose / tablet strength
Units
1 g = 1000 mg, 1 mg = 1000 mcg
Method
Convert the ordered dose and the stock strength to the same unit.
Use desired over have times quantity: (D/H) × Q.
For weight-based doses, multiply by the weight in kg first, then divide the daily dose by the number of doses.
Estimate first and check that the answer is reasonable.
IV infusion rates
Pump rate
mL/h = volume (mL)/time (h)
Drip rate
drops/min = volume (mL) × drop factor / time (min)
Infusion time
time (h) = volume (mL)/rate (mL/h)
Method
Pump rate in mL/h: volume divided by time in hours.
Drip rate in drops/min: volume × drop factor divided by time in minutes.
For time remaining: volume left divided by the rate.
Round as the question or the equipment requires.
2Practice problems
1.Maternity & obstetric nursingMedium
A pregnant woman takes warfarin for a mechanical heart valve. Why is she usually switched to heparin for much of the pregnancy?
AWarfarin crosses the placenta and can harm the fetus
BWarfarin is ineffective in pregnancy
CHeparin can be taken as a tablet once a day
DHeparin crosses the placenta better and also protects the fetus
2.Maternity & obstetric nursingHard
A woman in labour is receiving oxytocin. The tracing now shows recurrent late decelerations. Which action should the nurse take first?
AIncrease the oxytocin rate to speed up the birth
BDocument the pattern and reassess in 30 minutes
CHelp her lie flat on her back
DStop the oxytocin infusion
3.Dosage calculationsMedium
A vial contains 2 g of powder. The label says: add 7.4 mL of water for injection to give a total volume of 8 mL. The prescription is 300 mg. What volume V of the reconstituted solution do you give?
2 g+ 7.4 mL → 8 mL300 mg
V = mL
4.Dosage calculationsHard
You must prepare 1000 mL of a 2.5% (w/v) solution from a 20% (w/v) stock solution. How much water W must be added to the stock?
C₁ = 20%C₂ = 2.5%V₂ = 1000 mL
W = mL
5.IV infusion ratesMedium
An infusion is ordered at 50 mL/h, but no pump is available. It runs by gravity through a giving set of 60 gtt/mL. Find the drip rate R in drops per minute.
50 mL/h60 gtt/mL
R = gtt/min
6.IV infusion ratesHard
250 mg of a drug is diluted in 250 mL and given by gravity through a set of 60 gtt/mL. The order is 60 mg per hour. Find the drip rate R in drops per minute.
250 mg/250 mL60 mg/h60 gtt/mL
R = gtt/min
3Solutions
1.Maternity & obstetric nursing
Answer: A · Warfarin crosses the placenta and can harm the fetus
Why this is the answer
Warfarin crosses the placenta and is teratogenic and can cause fetal bleeding. Heparins are large molecules that do not cross the placenta, so low molecular weight heparin is commonly used instead.
Answer
A · Warfarin crosses the placenta and can harm the fetus
2.Maternity & obstetric nursing
Answer: D · Stop the oxytocin infusion
Why this is the answer
Stopping the oxytocin reduces contraction-related loss of placental flow. Other steps follow at once: a lateral position, an IV fluid bolus as ordered, checking maternal blood pressure and notifying the provider. Waiting or lying supine makes the hypoxia worse.
Answer
D · Stop the oxytocin infusion
3.Dosage calculations
Answer: V = 1.2 mL
Dose calculation: the amount to give equals what is prescribed divided by what you have, times the quantity it comes in: amount = (desired dose/stock strength) × stock volume. Always keep the units the same (convert g to mg, mg to mcg first) and check that the answer is sensible.
Concentration after mixing
2000 mg/8 mL = 250 mg/mL
Volume
V = 300/250 = 1.2 mL
Answer
V = 1.2 mL
4.Dosage calculations
Answer: W = 875 mL
Solution strengths: a percentage strength is grams per 100 mL, so 1% = 1 g/100 mL = 10 mg/mL. A ratio strength 1:1000 means 1 g in 1000 mL = 1 mg/mL; 1:10 000 is 0.1 mg/mL. For a dilution the amount of drug stays the same: C₁·V₁ = C₂·V₂.
Volume of stock
V₁ = 2.5·1000/20 = 125 mL
Water to add
W = 1000 − 125 = 875 mL
Answer
W = 875 mL
5.IV infusion rates
Answer: R = 50 gtt/min
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Millilitres per minute
50/60 = 0.8333 mL/min
Drip rate
R = 0.8333·60 = 50 gtt/min
Answer
R = 50 gtt/min
With a microdrip set (60 gtt/mL), gtt/min equals mL/h.
6.IV infusion rates
Answer: R = 60 gtt/min
Dose-based infusions: concentration = amount of drug in the bag/bag volume. Pump rate (mL/h) = dose per hour/concentration, and dose per hour = mL/h × concentration. Convert per-minute doses to per-hour (× 60) and keep the mass units the same (1 g = 1000 mg, 1 mg = 1000 mcg).