Maternity Nursing: cram pack

Formula sheets, the key method steps for every topic and 6 practice problems, with full solutions at the back.

New problemsBack to the course

In the print window, choose “Save as PDF” to keep a copy on your device.

1Formulas and methods

Maternity & obstetric nursing

Method

  1. Place the woman in time: weeks of pregnancy, stage of labour or day after birth, and decide what is normal at that point.
  2. Look for the patient in danger: the mother, the fetus or the newborn, or more than one of them.
  3. Link the finding to its cause: VEAL CHOP for decelerations, the four Ts for bleeding, BUBBLE-HE after birth.
  4. Choose the action that improves blood flow and oxygen first (side-lying, stopping oxytocin, fundal massage), then escalate.

Dosage calculations

Dose from strength
volume = dose / strength
Weight-based dose
dose = mg/kg × body weight
Tablets
number = dose / tablet strength
Units
1 g = 1000 mg, 1 mg = 1000 mcg

Method

  1. Convert the ordered dose and the stock strength to the same unit.
  2. Use desired over have times quantity: (D/H) × Q.
  3. For weight-based doses, multiply by the weight in kg first, then divide the daily dose by the number of doses.
  4. Estimate first and check that the answer is reasonable.

IV infusion rates

Pump rate
mL/h = volume (mL)/time (h)
Drip rate
drops/min = volume (mL) × drop factor / time (min)
Infusion time
time (h) = volume (mL)/rate (mL/h)

Method

  1. Pump rate in mL/h: volume divided by time in hours.
  2. Drip rate in drops/min: volume × drop factor divided by time in minutes.
  3. For time remaining: volume left divided by the rate.
  4. Round as the question or the equipment requires.

2Practice problems

1.Maternity & obstetric nursingMedium

What should parents be taught about the water for a newborn's bath?

  1. ACheck that it is warm, not hot, before the baby goes in
  2. BUse very hot water so that germs on the skin are killed
  3. CLeave the baby briefly if the water is only shallow
  4. DAdd adult bubble bath to soften the baby's skin
2.Maternity & obstetric nursingHard

The partner of a woman receiving magnesium sulfate asks what the drug is for. Which answer is accurate?

  1. AIt is the main drug that lowers her blood pressure
  2. BIt speeds up labour
  3. CIt helps prevent seizures caused by pre-eclampsia
  4. DIt stops the baby from growing too large
3.Dosage calculationsMedium
1%20 mLm = ? mg

How many milligrams of drug m are in 20 mL of a 1% (w/v) solution?

1% w/v20 mL
m = mg
4.Dosage calculationsHard
00.10.20.30.40.50.60.70.80.911 mL

The prescription is 700 units of a drug that comes as 1000 units/mL. Draw up the dose in the 1 mL syringe: what volume V do you give?

700 units1000 units/mL
V = mL
5.IV infusion ratesMedium
410 mLleft? mL/h8 h left

500 mL was ordered over 12 hours. After 4 hours you find that 410 mL is still in the bag, and the order must still finish on time. To what rate R in mL/h must the pump be reset?

500 mL / 12 hafter 4 h: 410 mL
R = mL/h
6.IV infusion ratesHard
200 mg50 mL20 mL/h? mg/h

A bag contains 200 mg of a drug in 50 mL and runs at 20 mL/h. How many milligrams per hour D does the patient receive?

200 mg/50 mL20 mL/h
D = mg/h

3Solutions

1.Maternity & obstetric nursing

Answer: A · Check that it is warm, not hot, before the baby goes in

Why this is the answer

Bath water should be comfortably warm, about 37 °C (98.6 °F), checked with a thermometer or the elbow, and the baby is never left alone, even in shallow water. Plain water or a mild baby cleanser is used. Some guidance, such as in the US, advises sponge baths until the cord stump has fallen off.

Answer

A · Check that it is warm, not hot, before the baby goes in
2.Maternity & obstetric nursing

Answer: C · It helps prevent seizures caused by pre-eclampsia

Why this is the answer

Magnesium sulfate is given to prevent and treat eclamptic seizures. It is not an effective antihypertensive, so severe hypertension needs separate drugs.

Answer

C · It helps prevent seizures caused by pre-eclampsia
3.Dosage calculations

Answer: m = 200 mg

Solution strengths: a percentage strength is grams per 100 mL, so 1% = 1 g/100 mL = 10 mg/mL. A ratio strength 1:1000 means 1 g in 1000 mL = 1 mg/mL; 1:10 000 is 0.1 mg/mL. For a dilution the amount of drug stays the same: C₁·V₁ = C₂·V₂.

Concentration

1% = 1 g/100 mL = 10 mg/mL

Mass of drug

m = 10·20 = 200 mg

Answer

m = 200 mg
4.Dosage calculations

Answer: V = 0.7 mL

Drawing up a dose: volume = (prescribed dose/stock strength) × stock volume. Convert to the same units first, then check that the volume fits the syringe and lands on one of its graduations.

Volume

V = 700/1000 = 0.7 mL

On the syringe

On this 1 mL syringe every small line is 0.01 mL.

Answer

V = 0.7 mL
5.IV infusion rates

Answer: R = 51.25 mL/h

Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.

Original rate

500/12 = 41.67 mL/h

New rate

R = 410/8 = 51.25 mL/h

Answer

R = 51.25 mL/h

Many hospitals allow such an adjustment up to 25% without a new order; check local policy.

6.IV infusion rates

Answer: D = 80 mg/h

Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.

Concentration

200/50 = 4 mg/mL

Dose rate

D = 4·20 = 80 mg/h

Answer

D = 80 mg/h

ExamProblems · examproblems.com/courses/maternity-nursing