Formula sheets, the key method steps for every topic and 10 practice problems, with full solutions at the back.
A child weighing 34 kg is prescribed 5 mg/kg of a drug. The stock solution contains 25 mg/mL. Draw up the dose: what volume V do you give?
The prescription is 3950 units of a drug that comes as 5000 units/mL. Draw up the dose in the 1 mL syringe: what volume V do you give?
A drip runs at 35 gtt/min through a set of 20 gtt/mL. How many millilitres V does the patient receive in 6 hours?
1000 mg of a drug is diluted in 500 mL and given by gravity through a set of 60 gtt/mL. The order is 200 mg per hour. Find the drip rate R in drops per minute.
Practice exercise (made-up values, not clinical guidance). A practice protocol calls for a heparin bolus of 80 units/kg for a patient who weighs 57 kg. The vial contains 5 000 units/mL. What volume V do you draw up? Round to two decimal places.
Practice exercise (made-up values, not clinical guidance). A dobutamine infusion of 500 mg in 250 mL runs at 28 mL/h. The patient weighs 68 kg. What dose D in mcg/kg/min is the patient receiving? Round to one decimal place.
Practice exercise (made-up values, not clinical guidance). The record shows a patient's intake and output for one 12-hour shift. The IV infusion ran at the rate shown for the whole shift. Find the fluid balance B = intake − output in mL (a negative answer means a net loss).
Practice exercise (made-up values, not clinical guidance). A 1000 mL bag was started at 11:45 and runs by pump at 60 mL/h. How many mL V are left in the bag at 19:45?
Practice exercise (made-up values, not clinical guidance). A patient’s temperature is 98.2 °F. Convert it to degrees Celsius T with °C = (°F − 32) × 5/9. Round to one decimal place.
Practice exercise (made-up values, not clinical guidance). An infusion starts at 19:55 and finishes at 02:15 the next morning (24-hour clock). How many minutes t did it run?
Answer: V = 6.8 mL
Drawing up a dose: volume = (prescribed dose/stock strength) × stock volume. Convert to the same units first, then check that the volume fits the syringe and lands on one of its graduations.
On this 10 mL syringe every small line is 0.2 mL.
Answer: V = 0.79 mL
Drawing up a dose: volume = (prescribed dose/stock strength) × stock volume. Convert to the same units first, then check that the volume fits the syringe and lands on one of its graduations.
On this 1 mL syringe every small line is 0.01 mL.
Answer: V = 630 mL
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Answer: R = 100 gtt/min
Dose-based infusions: concentration = amount of drug in the bag/bag volume. Pump rate (mL/h) = dose per hour/concentration, and dose per hour = mL/h × concentration. Convert per-minute doses to per-hour (× 60) and keep the mass units the same (1 g = 1000 mg, 1 mg = 1000 mcg).
Answer: V = 0.91 mL
Heparin and insulin infusions: concentration = units in the bag/bag volume (units/mL). Pump rate (mL/h) = units per hour/concentration, and units per hour = mL/h × concentration. For a weight-based order, units/h = units/kg/h × weight first. A bolus volume = units needed/vial strength. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: D = 13.7 mcg/kg/min
Titrated drips: first find the concentration in mcg/mL (mg × 1000/mL). For a weight-based order, mcg/min = mcg/kg/min × weight. Then mL/h = mcg/min × 60/concentration. Working backwards, mcg/kg/min = mL/h × concentration/(60 × weight). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: B = −250 mL
Intake and output: intake counts everything that goes in (oral fluids, IV infusions, IV medications and flushes, tube feeds); ice chips count as half their volume. Output counts urine, drains, vomit and other losses. Balance = total intake − total output; a negative balance is a net loss. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Negative: the patient lost more fluid than went in.
Answer: V = 520 mL
Infusion time: time (h) = volume to infuse (mL)/rate (mL/h); use the volume still left in the bag, not the bag size. Volume infused = rate × time. Convert decimal hours to hours and minutes with the fraction × 60 (0.5 h = 30 min, not 50 min). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: T = 36.8 °C
Temperature: °C = (°F − 32) × 5/9 and °F = °C × 9/5 + 32. Subtract 32 before you multiply when going from °F, and add 32 after you multiply when going from °C. A quick check: 37 °C is 98.6 °F, and every 1 °C is 1.8 °F.
Answer: t = 380 min
24-hour clock: from 1 PM onwards add 12 to the hour (3:45 PM = 15:45). Midnight to 12:59 AM is 00:00–00:59, and 12:00–12:59 PM stays 12:00–12:59. Going back, subtract 12 from hours 13–23 and add PM; hours 00 become 12 AM. Count time across midnight in two parts: up to 24:00 (00:00), then from 00:00 on.
This is independent practice material. ExamProblems is not affiliated with or endorsed by the organisation that runs this exam, and the exam name is used only to describe the content. NCLEX®, NCLEX-RN® and NCLEX-PN® are trademarks of the National Council of State Boards of Nursing, Inc. (NCSBN), which is not affiliated with ExamProblems and does not endorse it or vouch for its accuracy.
ExamProblems · examproblems.com/courses/nclex-dosage-calculations