Formula sheets, the key method steps for every topic and 10 practice problems, with full solutions at the back.
A child weighing 6 kg is prescribed 3 mg/kg of a drug. The stock solution contains 10 mg/mL. Draw up the dose: what volume V do you give?
You must prepare 250 mL of a 5% (w/v) solution from a 20% (w/v) stock solution. What volume of stock V₁ do you need?
1000 mL was ordered over 10 hours. After 2 hours you find that 930 mL is still in the bag, and the order must still finish on time. To what rate R in mL/h must the pump be reset?
An infusion of 50 mg in 500 mL runs at 3 mL/h. How many micrograms per minute D does the patient receive?
Practice exercise (made-up values, not clinical guidance). A practice protocol calls for a heparin bolus of 60 units/kg for a patient who weighs 102 kg. The vial contains 5 000 units/mL. What volume V do you draw up? Round to one decimal place.
Practice exercise (made-up values, not clinical guidance). A dobutamine infusion of 500 mg in 250 mL runs at 15 mL/h. The patient weighs 108 kg. What dose D in mcg/kg/min is the patient receiving? Round to one decimal place.
Practice exercise (made-up values, not clinical guidance). The record shows a patient's intake and output for one 8-hour shift. The IV infusion ran at the rate shown for the whole shift. Find the total intake I in mL. Count ice chips as half their volume.
Practice exercise (made-up values, not clinical guidance). A 500 mL bag runs by pump at 80 mL/h. At 21:00, 200 mL have already been infused. How many hours t until the bag is empty? Round to one decimal place.
Practice exercise (made-up values, not clinical guidance). A patient’s temperature is 35.4 °C. Convert it to degrees Fahrenheit T with °F = °C × 9/5 + 32. Round to one decimal place.
Practice exercise (made-up values, not clinical guidance). An infusion starts at 17:25 and finishes at 08:00 the next morning (24-hour clock). How many hours t did it run? Give the answer in hours as a decimal, rounded to two decimal places.
Answer: V = 1.8 mL
Drawing up a dose: volume = (prescribed dose/stock strength) × stock volume. Convert to the same units first, then check that the volume fits the syringe and lands on one of its graduations.
On this 10 mL syringe every small line is 0.2 mL.
Answer: V₁ = 62.5 mL
Solution strengths: a percentage strength is grams per 100 mL, so 1% = 1 g/100 mL = 10 mg/mL. A ratio strength 1:1000 means 1 g in 1000 mL = 1 mg/mL; 1:10 000 is 0.1 mg/mL. For a dilution the amount of drug stays the same: C₁·V₁ = C₂·V₂.
Answer: R = 116.3 mL/h
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Many hospitals allow such an adjustment up to 25% without a new order; check local policy.
Answer: D = 5 mcg/min
Dose-based infusions: concentration = amount of drug in the bag/bag volume. Pump rate (mL/h) = dose per hour/concentration, and dose per hour = mL/h × concentration. Convert per-minute doses to per-hour (× 60) and keep the mass units the same (1 g = 1000 mg, 1 mg = 1000 mcg).
Answer: V = 1.2 mL
Heparin and insulin infusions: concentration = units in the bag/bag volume (units/mL). Pump rate (mL/h) = units per hour/concentration, and units per hour = mL/h × concentration. For a weight-based order, units/h = units/kg/h × weight first. A bolus volume = units needed/vial strength. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: D = 4.6 mcg/kg/min
Titrated drips: first find the concentration in mcg/mL (mg × 1000/mL). For a weight-based order, mcg/min = mcg/kg/min × weight. Then mL/h = mcg/min × 60/concentration. Working backwards, mcg/kg/min = mL/h × concentration/(60 × weight). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: I = 2010 mL
Intake and output: intake counts everything that goes in (oral fluids, IV infusions, IV medications and flushes, tube feeds); ice chips count as half their volume. Output counts urine, drains, vomit and other losses. Balance = total intake − total output; a negative balance is a net loss. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: t = 3.8 h
Infusion time: time (h) = volume to infuse (mL)/rate (mL/h); use the volume still left in the bag, not the bag size. Volume infused = rate × time. Convert decimal hours to hours and minutes with the fraction × 60 (0.5 h = 30 min, not 50 min). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
That is about 3 h 45 min, so the bag runs out at about 00:45.
Answer: T = 95.7 °F
Temperature: °C = (°F − 32) × 5/9 and °F = °C × 9/5 + 32. Subtract 32 before you multiply when going from °F, and add 32 after you multiply when going from °C. A quick check: 37 °C is 98.6 °F, and every 1 °C is 1.8 °F.
Answer: t = 14.58 h
24-hour clock: from 1 PM onwards add 12 to the hour (3:45 PM = 15:45). Midnight to 12:59 AM is 00:00–00:59, and 12:00–12:59 PM stays 12:00–12:59. Going back, subtract 12 from hours 13–23 and add PM; hours 00 become 12 AM. Count time across midnight in two parts: up to 24:00 (00:00), then from 00:00 on.
This is independent practice material. ExamProblems is not affiliated with or endorsed by the organisation that runs this exam, and the exam name is used only to describe the content. NCLEX®, NCLEX-RN® and NCLEX-PN® are trademarks of the National Council of State Boards of Nursing, Inc. (NCSBN), which is not affiliated with ExamProblems and does not endorse it or vouch for its accuracy.
ExamProblems · examproblems.com/courses/nclex-dosage-calculations