Formula sheets, the key method steps for every topic and 10 practice problems, with full solutions at the back.
A dose of 100 mg is needed from a 5% (w/v) solution. What volume V contains this dose?
The prescription is 560 units of a drug that comes as 1000 units/mL. Draw up the dose in the 1 mL syringe: what volume V do you give?
Infuse 500 mL over 2 hours with a giving set of 10 gtt/mL. Find the drip rate R in drops per minute. Round to the nearest whole number.
A bag contains 400 mg of a drug in 50 mL and runs at 25 mL/h. How many milligrams per hour D does the patient receive?
Practice exercise (made-up values, not clinical guidance). An infusion contains 50 units of regular insulin in 50 mL. The order is 5 units/h. Find the pump rate R in mL/h. Round to one decimal place.
Practice exercise (made-up values, not clinical guidance). A bag contains dopamine 800 mg in 500 mL. The order is 5 mcg/kg/min for a patient who weighs 75 kg. At what rate R do you set the pump, in mL/h? Round to one decimal place.
Practice exercise (made-up values, not clinical guidance). The record shows a patient's intake and output for one 8-hour shift. The IV infusion ran at the rate shown for the whole shift. Find the fluid balance B = intake − output in mL (a negative answer means a net loss). Count ice chips as half their volume.
Practice exercise (made-up values, not clinical guidance). A 1000 mL bag was started at 11:00 and runs by pump at 80 mL/h. How many mL V are left in the bag at 17:00?
Practice exercise (made-up values, not clinical guidance). A newborn weighs 6 lb 11 oz. Using 1 lb = 16 oz and 1 kg = 2.2 lb, find the weight m in kilograms. Round to two decimal places.
Practice exercise (made-up values, not clinical guidance). An infusion starts at 19:40 and finishes at 01:50 the next morning (24-hour clock). How many minutes t did it run?
Answer: V = 2 mL
Solution strengths: a percentage strength is grams per 100 mL, so 1% = 1 g/100 mL = 10 mg/mL. A ratio strength 1:1000 means 1 g in 1000 mL = 1 mg/mL; 1:10 000 is 0.1 mg/mL. For a dilution the amount of drug stays the same: C₁·V₁ = C₂·V₂.
Answer: V = 0.56 mL
Drawing up a dose: volume = (prescribed dose/stock strength) × stock volume. Convert to the same units first, then check that the volume fits the syringe and lands on one of its graduations.
On this 1 mL syringe every small line is 0.01 mL.
Answer: R = 42 gtt/min
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
At the bedside you round to the nearest whole drop: 42 gtt/min.
Answer: D = 200 mg/h
Infusion rates: a pump is set in mL/h = volume/time in hours. A gravity drip is counted in drops per minute: gtt/min = volume (mL) × drop factor (gtt/mL)/time (min). The drop factor is printed on the tubing package: macrodrip sets deliver 10, 15 or 20 gtt/mL (blood sets often 10 gtt/mL in the US, 15 in the UK) and microdrip sets 60 gtt/mL. Always use the drop factor the question or package gives.
Answer: R = 5 mL/h
Heparin and insulin infusions: concentration = units in the bag/bag volume (units/mL). Pump rate (mL/h) = units per hour/concentration, and units per hour = mL/h × concentration. For a weight-based order, units/h = units/kg/h × weight first. A bolus volume = units needed/vial strength. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: R = 14.1 mL/h
Titrated drips: first find the concentration in mcg/mL (mg × 1000/mL). For a weight-based order, mcg/min = mcg/kg/min × weight. Then mL/h = mcg/min × 60/concentration. Working backwards, mcg/kg/min = mL/h × concentration/(60 × weight). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: B = 450 mL
Intake and output: intake counts everything that goes in (oral fluids, IV infusions, IV medications and flushes, tube feeds); ice chips count as half their volume. Output counts urine, drains, vomit and other losses. Balance = total intake − total output; a negative balance is a net loss. The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Positive: more fluid went in than came out.
Answer: V = 520 mL
Infusion time: time (h) = volume to infuse (mL)/rate (mL/h); use the volume still left in the bag, not the bag size. Volume infused = rate × time. Convert decimal hours to hours and minutes with the fraction × 60 (0.5 h = 30 min, not 50 min). The numbers are for practice only; at the bedside always follow local protocols and have high-risk doses double-checked.
Answer: m = 3.04 kg
Household measures and weight: nursing exams use rounded equivalents: 1 teaspoon (tsp) = 5 mL, 1 tablespoon (tbsp) = 15 mL = 3 tsp, 1 fluid ounce (fl oz) = 30 mL = 2 tbsp, and 1 cup = 8 fl oz = 240 mL. For weight, 1 kg = 2.2 lb and 1 lb = 16 oz; for length, 1 inch = 2.54 cm. Set the conversion up so that the unit you do not want cancels out.
Answer: t = 370 min
24-hour clock: from 1 PM onwards add 12 to the hour (3:45 PM = 15:45). Midnight to 12:59 AM is 00:00–00:59, and 12:00–12:59 PM stays 12:00–12:59. Going back, subtract 12 from hours 13–23 and add PM; hours 00 become 12 AM. Count time across midnight in two parts: up to 24:00 (00:00), then from 00:00 on.
This is independent practice material. ExamProblems is not affiliated with or endorsed by the organisation that runs this exam, and the exam name is used only to describe the content. NCLEX®, NCLEX-RN® and NCLEX-PN® are trademarks of the National Council of State Boards of Nursing, Inc. (NCSBN), which is not affiliated with ExamProblems and does not endorse it or vouch for its accuracy.
ExamProblems · examproblems.com/courses/nclex-dosage-calculations