Formula sheets, the key method steps for every topic and 20 practice problems, with full solutions at the back.
A car driving at 45 km/h brakes with a constant deceleration of 5.5 m/s² until it stops. How long does braking take? Find t.
A ball is thrown straight up at 7 m/s from the edge of a roof 15 m above the ground. Ignore air resistance and use g = 9.81 m/s². How long after the throw does it hit the ground? Find t.
A 35 kg box is pushed up a ramp at 25° to the horizontal at constant speed, by a force parallel to the ramp. The coefficient of kinetic friction is 0.25. Use g = 9.81 m/s². Find the pushing force F.
A 2.5 kg block on a horizontal table is connected by a light string over a frictionless pulley to a hanging 1.5 kg mass. The coefficient of kinetic friction between block and table is 0.25. Use g = 9.81 m/s². Find the acceleration a of the system.
A ball is kicked from level ground at 28 m/s and 30° above the horizontal towards a wall 14 m away. Ignore air resistance and use g = 9.81 m/s². At what height y does the ball pass the wall?
A ball is launched at 30 m/s and 60° above the horizontal from the top of a 30 m cliff. Ignore air resistance and use g = 9.81 m/s². Find the speed v with which it hits the ground.
A car takes a flat curve of radius 115 m. The coefficient of static friction between tyres and road is 0.7. Use g = 9.81 m/s². Find the highest speed vmax at which the car can take the curve without skidding.
A ball on a string 1.3 m long is swung in a vertical circle. Use g = 9.81 m/s². What is the smallest speed vmin at the top for which the string just stays tight?
A 4 kg block slides 5 m down a slope at 25° to the horizontal, with a coefficient of kinetic friction of 0.35. Find the work Wf done against friction.
A 2.5 kg block is released from rest at height 2 m on a smooth ramp. At the bottom it crosses a rough horizontal strip 1 m long (μ = 0.2) and then runs onto a spring (k = 1500 N/m) on a smooth surface. Find the maximum compression x of the spring.
A 19 kg projectile moving horizontally at 16 m/s explodes into two fragments that move along the same line. The 7 kg fragment continues forwards at 55 m/s. Find the velocity v′2 of the 12 kg fragment (positive in the original direction).
At a crossing a 1200 kg car travelling east at 10 m/s collides with a 900 kg car travelling north at 11 m/s. The cars lock together. Find the direction θ of the wreck just after the collision, measured north of east.
A uniform slender rod of mass 10.5 kg and length 0.9 m is pinned at one end and held horizontal. It is released from rest. Use g = 9.81 m/s². Find the acceleration atip of the free end just after release.
A uniform slender rod of mass 8.5 kg and length 1.4 m hangs at rest from a frictionless pivot at its top end. A 35 g bullet moving horizontally at 420 m/s hits the rod 1.21 m below the pivot and stays embedded. Use g = 9.81 m/s². Find the largest angle φ from the vertical through which the rod swings.
A 7.5 kW motor running at 1440 rpm drives a pinion with 12 teeth, which meshes with a gear with 24 teeth. The gear pair has an efficiency of 98%. Find the torque T1 on the motor shaft.
A 1.1 kW motor at 1450 rpm drives gear A (18 teeth), which meshes with gear B (48 teeth). Gear C (20 teeth) on the same shaft as B drives gear D (36 teeth) on the output shaft. Each gear mesh has an efficiency of 96%. Find the output torque Tout.
A 0.9 kg mass on a spring with k = 50 N/m oscillates on a frictionless surface with an amplitude of 9 cm. Find its speed v when it is 3 cm from equilibrium.
A 1 kg mass is attached to the lower end of an unstretched vertical spring with k = 360 N/m and released from rest. Use g = 9.81 m/s². Find the greatest speed vmax of the mass.
In a free-vibration test of a damped mass–spring system, a displacement peak of 25 mm is followed 2 cycles later by a peak of 7.1 mm. Find the damping ratio ζ.
A 20 kg mass hangs from two springs side by side (in parallel), with stiffnesses k₁ = 30 kN/m and k₂ = 60 kN/m. The mass stays level. Ignore damping and the masses of the springs. Find the natural frequency fn of vertical vibration in Hz.
Answer: t = 2.273 s
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Answer: t = 2.602 s
Motion with constant acceleration: v = v₀ + a·t, s = v₀·t + ½·a·t² and v² = v₀² + 2·a·s. Pick the equation that contains the three things you know and the one you want, and keep the signs consistent with one positive direction.
Up is positive and the ground is h₀ below the starting point.
Only the positive root is physical.
Answer: F = 222.9 N
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Constant speed: the forces balance.
Answer: a = 2.146 m/s²
Newton’s second law: the net force on a body equals its mass times its acceleration, ΣF = m·a. Draw a free-body diagram, choose a positive direction along the motion, and add every force in that direction: applied forces, friction μ·N against the motion, and the components of gravity.
Answer: y = 6.448 m
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
The ball is still rising at the wall.
Answer: v = 38.58 m/s
Projectile motion: with no air resistance, x = vxt and y = h + vyt − ½gt². The two directions are independent except that they share the same time.
Energy or v² = v₀² + 2as in the vertical direction.
Check with energy: v² = v₀² + 2gh.
Answer: vmax = 28.1 m/s
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Answer: vmin = 3.571 m/s
Uniform circular motion: an object moving at speed v on a circle of radius r accelerates towards the centre with a = v²/r, so it needs a net inward force F = m·v²/r. That force is supplied by something real: friction, tension, gravity or a normal force.
Answer: Wf = 62.24 J
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
Answer: x = 24.26 cm
Work–energy principle: the change in kinetic energy equals the work done by all forces. Writing gravity and springs as potential energy (mgh and ½kx²) turns this into a balance: initial energy = final energy + energy lost to friction (μN·d).
The ramp is smooth, so only the strip removes energy.
Answer: v′2 = −6.75 m/s
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
The minus sign means the second fragment flies backwards.
Answer: θ = 39.52 °
Conservation of momentum: when no external force acts during a collision, the total momentum Σm·v before equals the total after. Velocities have a direction, so pick a positive direction and give velocities the other way a minus sign. In an elastic collision kinetic energy is conserved too; in a perfectly inelastic one the bodies stick together.
Answer: atip = 14.71 m/s²
Rotation about a fixed axis: the sum of the moments about the axis equals I·α (ΣM = I·α), just as ΣF = m·a for translation. In energy form, a torque T turning through an angle θ (in radians) does work T·θ, which changes the kinetic energy ½·I·ω²; gravity adds or removes m·g·Δh of the centre of mass. Power is P = T·ω.
At the moment of release ω = 0, so there is no centripetal acceleration and the centre accelerates straight down.
atip = 1.5·g for any length: the free end falls faster than a dropped stone.
Answer: φ = 58.68 °
Rolling and angular momentum: a body rolling without slipping has v = ω·r, so its kinetic energy is ½·m·v² + ½·I·ω² = ½·m·v²·(1 + I/(m·r²)). Down a slope that gives a = g·sin θ/(1 + I/(m·r²)). When no external moment acts about an axis, the angular momentum about that axis stays constant, I₁·ω₁ = I₂·ω₂, even if kinetic energy is lost.
The pivot force passes through the pivot, so it has no moment there during the impact.
Answer: T1 = 49.74 N·m
Gear trains: meshing gears have the same speed at the teeth, so n₁·N₁ = n₂·N₂: the gear with fewer teeth turns faster. Gears on one shaft turn at the same speed. Power is passed on (minus losses), so torque goes up when speed goes down: T₂ = T₁·(N₂/N₁)·η, and P = T·ω with ω = 2π·n/60.
Answer: Tout = 32.05 N·m
Gear trains: meshing gears have the same speed at the teeth, so n₁·N₁ = n₂·N₂: the gear with fewer teeth turns faster. Gears on one shaft turn at the same speed. Power is passed on (minus losses), so torque goes up when speed goes down: T₂ = T₁·(N₂/N₁)·η, and P = T·ω with ω = 2π·n/60.
Answer: v = 0.6325 m/s
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
Answer: vmax = 0.517 m/s
Simple harmonic motion: a mass m on a spring of stiffness k oscillates with angular frequency ω = √(k/m) and period T = 2π/ω = 2π·√(m/k). A simple pendulum of length L has T = 2π·√(L/g). With amplitude A, the largest speed is A·ω, the largest acceleration A·ω² and the energy ½·k·A².
The speed is largest at equilibrium.
Answer: ζ = 0.09967
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Answer: fn = 10.68 Hz
Free vibration of a mass–spring system: the undamped natural frequency is ωn = √(k/m) in rad/s, and fn = ωn/(2π) in Hz. A viscous damper c gives the damping ratio ζ = c/cc, with critical damping cc = 2·√(k·m) = 2·m·ωn. An underdamped system (ζ < 1) oscillates at ωd = ωn·√(1 − ζ²). Springs in parallel add, k = k₁ + k₂; springs in series add as reciprocals, 1/k = 1/k₁ + 1/k₂.
Springs side by side share the deflection and add their forces, so their stiffnesses simply add: k = k1 + k2.
ExamProblems · examproblems.com/courses/dynamics